Honda Civic/Acura Integra

since 1994 of release

Repair and car operation

Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
- Gear shifting box
   - 5-step manual box of gear shifting
      General information
      Replacement of epiploons of power shafts
      Check of a condition and replacement of a support of a transmission
      Removal and installation of draft of a drive of gear shifting
      Check and replacement of the sensor switch of fires of a backing
      Removal and RKPP installation
      Major maintenance of RKPP - the general information
   + 4-step and besstupenchaty automatic transmissions (ат and cvt)
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Replacement of epiploons of power shafts

Leakages of transmission oil appear are connected with wear or mechanical damage of epiploons of power shafts more often. Replacement of epiploons is made rather simply and does not demand removal of transmission from the car.

PERFORMANCE ORDER

1. Epiploons are located from both parties of a case of a transmission in introduction places in them power shafts. To Poddomkratta the car also establish it on props. A sign of leakage of oil through an epiploon are begin to flow oils on walls of a case of RKPP directly under power shafts.
2. Remove a power shaft (ы) (see. Head of clutch and power shafts).

3. By means of mount or a big screw-driver with a flat sting take an old epiploon from the landing nest in a transmission case (see an accompanying illustration).

4. If to take an epiploon mount or a screw-driver it is not possible, it is necessary to use a special stripper (ask in shops of automobile accessories).

5. Having used as an opravka a face head of the corresponding size or a piece of a pipe of suitable diameter, plant a new epiploon on the regular place (see an accompanying illustration). Track, that the epiploon appeared is planted in a nest strictly perpendicularly and on full depth. Grease epiploon sponges with transmission oil.

Opravka should rest only against the firm external region of a face surface of an epiploon.

6. Establish into place a power shaft (ы) – try not to damage sponges of a new epiploon (ов).