|
|
Honda Civic/Acura Integrasince 1994 of releaseRepair and car operation |
|
|
Honda Tsivik + Honda Civic and Acura Integra brand Cars + Maintenance instruction + Routine maintenance + Engine + cooling and heating Systems + Power supply system and release - Engine electric equipment Specifications Engine start from the auxiliary power supply Check of a condition and battery replacement Check of a condition and replacement of wires of the battery Ignition system - the general information Check of functioning of system of ignition Check of a condition and replacement of the coil of ignition Check of serviceability of functioning and replacement of the module of management with ignition (ICM) Removal and installation of the distributor of ignition Check of installation and adjustment of a corner of an advancing of ignition Charge system - the general information and precautionary measures Check of a condition of system of a charge Removal and generator installation Replacement of a regulator of tension and generator brushes Start system - the general information and precautionary measures Check of serviceability of functioning of a starter on the car (in situ) Removal and starter installation Removal and installation of the traction relay + Control systems of the engine + gear shifting Box + clutch and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment 
|
Engine electric equipment General information and precautionary measures The structure of electric equipment of the engine includes components of systems of ignition, a charge and start (see illustrations below). In view of that these systems have a direct bearing on operation of the engine, they are considered separately from other onboard electric equipment, such as signal and lighting lights, monitors, etc., Head Onboard electric equipment is devoted to placement, a design and which principles of functioning.At service of components of systems of electric equipment it is necessary to observe special precautionary measures in order to avoid risk of failure of semi-conductor elements, and also for the purpose of prevention of receiving electrotraumas. Starting electric equipment service surely remove a watch, rings and other metal ornaments. Even at the disconnected battery the category of condensers at casual grounding of their plugs can lead to receiving electric shock or a strong burn. Do not allow polarity violation at battery connection. In structure of such components as the generator, or electronic control units enter semi-conductor elements which can be put out of action at the wrong connection of wires. At performance of start of the engine from the external power supply, or charger connection also observe polarity of connection of wires (see appropriate section in Introduction to the real Management). Never disconnect electroconducting from the battery, the generator or the diagnostic equipment at the working engine. Do not allow a provorachivaniye the engine of the disconnected generator. At all do not make stock-taking of target tension of the generator by grounding of its plugs. Do not apply to conductivity stock-taking in a chain the ohmmeters equipped manual dynamo car. At performance of any works on service of electric equipment watch, that the negative wire was disconnected from the battery. Before use of electroarc welding without fail disconnect the battery, the generator and such components, as RSM of systems of food/ignition in order to avoid risk of their damage The scheme of an arrangement of components of electric equipment of the engine in a motor compartment of the car (Civic) The scheme of an arrangement of components of electric equipment of the engine in a motor compartment of the car (Civic) |
|