Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
- Engine electric equipment
Specifications
Engine start from the auxiliary power supply
Check of a condition and battery replacement
Check of a condition and replacement of wires of the battery
Ignition system - the general information
Check of functioning of system of ignition
Check of a condition and replacement of the coil of ignition
Check of serviceability of functioning and replacement of the module of management with ignition (ICM)
Removal and installation of the distributor of ignition
Check of installation and adjustment of a corner of an advancing of ignition
Charge system - the general information and precautionary measures
Check of a condition of system of a charge
Removal and generator installation
Replacement of a regulator of tension and generator brushes
Start system - the general information and precautionary measures
Check of serviceability of functioning of a starter on the car (in situ)
Removal and starter installation
Removal and installation of the traction relay
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check of a condition and replacement of the coil of ignition
Check
|
|
1. Switch off ignition (the key should be turned in the situation OFF).
2. Remove from the distributor a cover, a begunok and the filter (at the corresponding complete set).
3. Disunite electric sockets of primary contour of the coil of ignition.
|
|
4a. By means of an ohmmeter measure resistance between plugs (And and In) primary winding of the coil (see accompanying illustrations). |
|
|
4b. Measurement of resistance of primary winding of the coil of ignition on models with the TES distributor. Compare result of measurement to requirements of Specifications. |
|
|
5a. Then measure resistance between the positive plug of primary winding (And) and the plug of a secondary winding (model with the Hitachi distributor). Again compare result to requirements of Specifications. |
|
|
5b. Measure resistance between the positive plug of primary winding (And) and the plug of a secondary winding (model with the TEC distributor). |
6. Remember that standard values of resistance of windings change with temperature. Values are given in Specifications for coil 21°С temperature.
7. If in any of the last two checks the result of measurement falls outside the limits an admissible range, replace the ignition coil. |
|
Replacement
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action! |
2. Remove from the distributor a cover and the filter (at the corresponding complete set) (see. Head Routine maintenance). Disconnect wires from plugs of primary contour of the coil.
|
|
3. Turn out two fixing screws (see an accompanying illustration) and take the ignition coil from distributor assembly. |
4. Installation is made upside-down. |
|
|
|
