|
Honda Civic/Acura Integrasince 1994 of releaseRepair and car operation |
|
Honda Tsivik + Honda Civic and Acura Integra brand Cars + Maintenance instruction + Routine maintenance + Engine + cooling and heating Systems + Power supply system and release - Engine electric equipment Specifications Engine start from the auxiliary power supply Check of a condition and battery replacement Check of a condition and replacement of wires of the battery Ignition system - the general information Check of functioning of system of ignition Check of a condition and replacement of the coil of ignition Check of serviceability of functioning and replacement of the module of management with ignition (ICM) Removal and installation of the distributor of ignition Check of installation and adjustment of a corner of an advancing of ignition Charge system - the general information and precautionary measures Check of a condition of system of a charge Removal and generator installation Replacement of a regulator of tension and generator brushes Start system - the general information and precautionary measures Check of serviceability of functioning of a starter on the car (in situ) Removal and starter installation Removal and installation of the traction relay + Control systems of the engine + gear shifting Box + clutch and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment |
Start system – the general information and precautionary measures General information The system provides an engine provorachivaniye for the purpose of its start. The main components of system are a starter with the traction relay established on it, the storage battery, the lock of ignition and connecting electroconducting. Starter assembly with the traction relay is fixed in a back part of the engine, near a transmission dome. At ignition key turn in the situation START power supply from the battery on a chain of management of start moves on the traction relay of a starter. The relay makes switching of a food of the battery directly on the starter electromotor. The motor starts to rotate, at the same time turning for a gear wreath of a flywheel / a driving disk a cranked shaft of the engine. Starter functioning on the models equipped with RKPP becomes possible only at the squeezed-out pedal of coupling. On models from AT an indispensable condition is transfer of the lever of the selector to the situation "R" or "N". Precautionary measures At performance of any works with components of system of start it is necessary to observe the following special precautionary measures: a) Remember that excessively long provorachivaniye of the engine a starter can lead to serious damages of the last as a result of an overheat. Never use a starter continuously further 15 seconds then it should allow to cool down within a minute - two; |
|