Honda Civic/Acura Integra

since 1994 of release

Repair and car operation



Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
- Engine electric equipment
   Specifications
   Engine start from the auxiliary power supply
   Check of a condition and battery replacement
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information
   Check of functioning of system of ignition
   Check of a condition and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management with ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation and adjustment of a corner of an advancing of ignition
   Charge system - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and generator installation
   Replacement of a regulator of tension and generator brushes
   Start system - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and starter installation
   Removal and installation of the traction relay
+ Control systems of the engine
+ gear shifting Box
+ Cцепление and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of the traction relay

On the Integra models the starter of manufacturing of the Nippondenso company with the fixed traction relay is used. In case of failure all assembly is subject to replacement. The description provided below belongs to Mitsubishi starters.


 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!


2. Remove a starter (see. Removal and starter installation).
3. Disconnect the big wire connecting the traction relay to the plug of the electromotor of a starter.

4. Turn out long bolts of fastening of a face cover to a reducer casing (see an accompanying illustration). Remove the case of anchor assembly.

5. Turn out fixing screws and separate a reducer casing from a forward cover of assembly (see an accompanying illustration).

6. Turn out fixing screws and separate a reducer casing from the traction relay (see an accompanying illustration).

7. Installation is made upside-down. Before assembly grease the lever of a drive and a plunzher of the traction relay with assembly greasing (see an accompanying illustration).