Honda Civic/Acura Integra

since 1994 of release

Repair and car operation

Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
- Engine electric equipment
   Specifications
   Engine start from the auxiliary power supply
   Check of a condition and battery replacement
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information
   Check of functioning of system of ignition
   Check of a condition and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management with ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation and adjustment of a corner of an advancing of ignition
   Charge system - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and generator installation
   Replacement of a regulator of tension and generator brushes
   Start system - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and starter installation
   Removal and installation of the traction relay
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Specifications

Ignition system

Ignition coil

Characteristic	Value
Civic (Hitachi distributor)
Resistance of primary winding, Ohm	0.45÷0.55
Resistance of a secondary winding, kiloohm	22.4÷33.6
Civic (TES distributor)
Resistance of primary winding, Ohm	0.63÷0.77
Resistance of a secondary winding, kiloohm	12.8÷19.2
Integra
Resistance of primary winding, Ohm	0.6÷0.8
Resistance of a secondary winding, kiloohm	12.8÷19.2

Installation of a corner of an advancing of ignition

Characteristic	Value
Civic
Models with RKPP D16Y5, D16Y8	12 ° ± 2 ° before VMT (Krasn.) at 450 ± 50 rpm
D16Y7
USA	12 ° ± 2 ° before VMT (Krasn.) at 670 ± 50 rpm
Canada	12 ° ± 2 ° before VMT (Krasn.) at 750 ± 50 rpm
Models with AT/CVT
USA	12 ° ± 2 ° before VMT (Krasn.) at 700 ± 50 rpm
Canada	12 ° ± 2 ° before VMT (Krasn.) at 750 ± 50 rpm
Integra
В18В1, В18С1	16 ° ± 2 ° (Krasn.) at 750 ± 50 rpm
В18С5	16 ° ± 2 ° (Krasn.) at 800 ± 50 rpm

Charge system

Characteristic	Value
Minimum admissible length of brushes of the generator, mm	1.6