Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
- Engine electric equipment
   Specifications
   Engine start from the auxiliary power supply
   Check of a condition and battery replacement
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information
   Check of functioning of system of ignition
   Check of a condition and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management with ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation and adjustment of a corner of an advancing of ignition
   Charge system - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and generator installation
   Replacement of a regulator of tension and generator brushes
   Start system - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and starter installation
   Removal and installation of the traction relay
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Removal and generator installation

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!


2. Previously having marked, disconnect from the generator electroconducting.

3a. Weaken an axial bolt of the generator.

3b. Weaken an adjusting bolt of the generator (see accompanying illustrations) and remove a driving belt.

4. For generator extraction from an impellent compartment it is necessary to dismantle partially the power shaft located under it. Disconnect the bottom end of a control lever from a suspension bracket rack (see. Head the Suspension bracket and a steering) also liberate the external end of the left power shaft from a wheel nave. On the Integra models the basic bearing of an intermediate shaft is required also отболтить from the engine block. (see an accompanying illustration) – for more details see. Head of clutch and power shafts.

5. Turn out adjusting and axial bolts and remove the generator from the engine (see an accompanying illustration).

6. In case of need generator replacements, take the block removed from the car with itself in shop as an example – the new generator should correspond on the technical characteristics failed. Compare plugs, – they should have the same numbering, the size and an arrangement. In summary, compare the identification marking which has been usually beaten out on the case of the block, or printed on the label tied up to it – identification numbers of old and replaceable generators should coincide.
7. Usually replaceable generators are delivered not complete with a driving pulley which in that case is necessary for rearranging from the old block.
8. Installation is made upside-down.
9. In summary adjust a tension of a driving belt (see. Routine maintenance).
10. For check of serviceability of functioning of the generator measure tension of a charge developed by it (see. Charge system - the general information and precautionary measures).