Honda Civic/Acura Integra

since 1994 of release

Repair and car operation

Check and replacement of the sensor switch of fires of a backing

Check

PERFORMANCE ORDER

1. First of all check a safety lock No. 19 condition on 7.5 And in the assembly block located under the dashboard. 2. Choose as the switching lever a reverse gear and include ignition – white signal lights of a backing should light up. Switch off ignition. 3. If fires do not join, check serviceability of the corresponding lamps in assemblies of the back combined lamps. 4. If a safety lock and lamps as it should be, find the sensor switch of fires of a backing in the top part of a case of RKPP (see an accompanying illustration), walk back on electroconducting to the socket, disunite the last and connect between two bared contacts an ohmmeter. 5. At the included reverse gear between contacts of the socket conductivity (the sensor switch will close) should take place. In any other position of the lever the sensor switch should be opened (conductivity is not present). 6. At negative results of the carried-out check replace the sensor switch. 7. If the switch as it should be, check serviceability of giving of a food on it. In the absence of tension check on break electroconducting on a chain site between the sensor switch and the assembly block of safety locks. If a food moves, check a chain site between the sensor switch and the back combined lamps.

Replacement

PERFORMANCE ORDER

1. Disconnect from the sensor switch electroconducting. 2. Turn out the sensor switch from a transmission case. 3. Remove and will throw out an old washer. 4. Replace a washer and establish the new sensor switch. 5. Connect electroconducting.