Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
- Gear shifting box
+ 5-step manual box of gear shifting
- 4-step and besstupenchaty automatic transmissions (ат and cvt)
General information
Problem diagnostics AT/CVT - the general information
Check and adjustment of a cable of management by a butterfly valve in the kick-down mode (TV cable) - the Integra models
Replacement and adjustment of a cable of gear shifting
Adjustment and replacement of the sensor switch of position of the lever of the selector of transfers
Blocking system - the general information, condition check, replacement and adjustment of an electromagnet of management
Check and replacement of electromagnetic valves of management with blocking
Removal and installation of 4-step and besstupenchaty automatic transmissions (AT and CVT)
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check and adjustment of a cable of management by a butterfly valve in the kick-down mode (TV cable) – the Integra models
|
|
The TV cable serves for a gas sbrasyvaniye at the moment of AT switching on a low gear in the kick-down mode, – it is not necessary to confuse it to a cable of a drive of a zaslonka from an accelerator pedal.
|
Check
|
|
1. Before starting check a TV cable, make sure of correctness of adjustments of a free wheeling of a cable of an accelerator (see. Head of the Power supply system and release) and idling turns (see. Head Routine maintenance).
2. Warm up the engine to normal working temperature.
3. By squeezing and an otpuskaniye of a pedal of gas make sure that the control lever on AT is synchronized by a butterfly valve with draft of an accelerator.
4. If synchronization is broken, make necessary adjustment of a TV cable (see below).
5. Ask the assistant to squeeze out against the stop a pedal of an accelerator and make sure that the lever of a drive of a butterfly valve on transmission has insignificant люфт.
6. Disconnect a cable tip from the lever.
7. Check freedom of a course of the lever. In case of identification of points of jamming, address for the help to experts in automatic transmissions.
8. Again connect a TV cable to the driving lever on transmission. |
|
Adjustment
|
|
1. Execute the procedures stated above in paragraphs 1 and 2.
2. Make sure that the lever of an accelerator is in the situation corresponding to the closed condition of the butterfly valve.
3. Weaken a TV cable lock-nut in its top part, near the throttle case.
4. Wring out the lever of a drive of a zaslonka in completely closed position, then choose люфт a TV cable as a way of pulling up of an adjusting nut.
5. Tighten a lock-nut.
6. Make sure of observance of synchronization and serviceability of functioning of the driving lever. Besides, track, that at completely squeezed out pedal of an accelerator the driving lever on transmission had an insignificant free wheeling. Absence small люфта speaks about malfunction of the lever or damage of the mechanism of management in transmission. |
|
|
|
лечение спины