Honda Civic/Acura Integra

since 1994 of release

Repair and car operation



Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
- Gear shifting box
   + 5-step manual box of gear shifting
   - 4-step and besstupenchaty automatic transmissions (ат and cvt)
      General information
      Problem diagnostics AT/CVT - the general information
      Check and adjustment of a cable of management by a butterfly valve in the kick-down mode (TV cable) - the Integra models
      Replacement and adjustment of a cable of gear shifting
      Adjustment and replacement of the sensor switch of position of the lever of the selector of transfers
      Blocking system - the general information, condition check, replacement and adjustment of an electromagnet of management
      Check and replacement of electromagnetic valves of management with blocking
      Removal and installation of 4-step and besstupenchaty automatic transmissions (AT and CVT)
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Replacement and adjustment of a cable of gear shifting

Replacement

Considered in the real Management of the car are equipped with safety cushions (SRS). At performance of any works near sensors of blows, a steering column or the dashboard disconnect SRS (see schemes of electric connections at the end of Head Onboard electric equipment).


 PERFORMANCE ORDER

1. Remove the central console (see. Head Body).

2. Transfer the selector lever to the situation "N" and remove a fixing clamp from a regulator of a driving cable (see an accompanying illustration).

3. To Poddomkratta the car also establish it on props. To Otboltita an arm of a cable of gear shifting (see an accompanying illustration).

4. Disconnect the holder of a cable from the floor panel, then liberate a cable from an assembly bracket (see an accompanying illustration).

5. Uncover a cable (see an accompanying illustration).

6. Give a fixing nut and remove the lever from a management rod. Try not to bend excessively a cable in the course of its removal and installation.

7. Installation is made upside-down. Do not forget to make cable adjustment (see below).

Adjustment

 PERFORMANCE ORDER

1. Remove the central console (see. Head Body).
2. Transfer the selector lever to the situation "N", then release a fixing clamp on assembly of a regulator of a cable (see an illustration the first illustration).

3. In a tip of a cable two openings are provided. Openings are located at an angle 90 ° that allows to make cable adjustment with a step in 1/4 turns. Track, that the opening in a regulator was accurately combined with a reciprocal opening in a tip (see an accompanying illustration).

4. If to achieve demanded combination of openings it is not possible, release a lock-nut of a cable and make necessary adjustment. Again strongly tighten a lock-nut.
5. Establish on a regulator a fixing clamp. If at installation of a clamp there is its jamming, it is necessary to make sure of correctness of adjustment of a cable.
6. Turn out fixing screws and correct position of the display panel of assembly of switching achieving alignment of its labels.
7. Screw fixing screws and strongly tighten them.

8. Make sure of combination white risks in the basis of the lever of the selector from well-aimed “N” on the display panel (see an accompanying illustration). If labels are combined not accurately, correct position of the panel.

9. Start the engine and check serviceability of switching of the lever of the selector in all possible provisions. If it is not possible to choose any from modes of movement it is not possible, address to section 2 materials.