Honda Civic/Acura Integra

since 1994 of release

Repair and car operation



Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
- Engine
   + engine Repair without extraction from the car - the Civic models
   - Engine repair without extraction from the car - the Integra models
      General information
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of a cover of a head of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      VTEC systems - the general information and check of a condition of components
      Removal, check of a condition and installation of camshafts and assembly of yokes
      Replacement of klapanny springs with plates and maslootrazhatelny caps
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Flywheel replacement / driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + General and major maintenance of the engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ Cцепление and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Replacement of klapanny springs with plates and maslootrazhatelny caps

Replacement of the broken klapanny springs and defective maslootrazhatelny caps of cores of valves on the VTEC models demands preliminary dismantle of a head of cylinders. Remove camshafts and a head of cylinders, then address to Part materials the General and major maintenance of the engine of the present Chapter and, operating according to the instructions provided in appropriate section, remove valves, klapanny springs and maslootrazhatelny caps.

On the models which have not been equipped with VTEC system, replacement of considered components is made without head dismantle. The description of procedure is provided in VTEC Systems - the general information and check of a condition of components of the Part engine Repair without extraction from the car - the Civic models of the present Chapter.