Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
- Engine
   + engine Repair without extraction from the car - the Civic models
   - Engine repair without extraction from the car - the Integra models
      General information
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of a cover of a head of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      VTEC systems - the general information and check of a condition of components
      Removal, check of a condition and installation of camshafts and assembly of yokes
      Replacement of klapanny springs with plates and maslootrazhatelny caps
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Flywheel replacement / driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + General and major maintenance of the engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Removal and installation of a final collector

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!


2. To Poddomkratta a car front also establish it on props. To Otboltita an assembly bracket also disconnect from a final collector a reception pipe of system of production of the fulfilled gases (see an accompanying illustration). If the fixture of a pipe does not give in to an otdavaniye, previously moisten it with getting structure.

3. Remove from a final collector the thermofilter (see an accompanying illustration). It is also expedient to impregnate fixture with getting structure previously.

4. Give fixing nuts (see an accompanying illustration) and separate a final collector from a head of cylinders.

Installation

 PERFORMANCE ORDER

1. Will throw out old laying, then scratch out its fragments from interfaced surfaces of a final collector and a head of cylinders. Wipe surfaces the rags moistened in acetone.
2. Having replaced laying, establish a collector on the regular place and fix it nuts. Moving in the direction from the center outside, in a diagonal order tighten fixture with demanded effort (see. Specifications).
3. Further installation is made as it should be, the return to a dismantle order.
4. Start the engine and check it on existence of signs of leakages of the fulfilled gases through joints of a final collector with a head of cylinders and a reception pipe of system of release.