Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
- Engine
+ engine Repair without extraction from the car - the Civic models
- Engine repair without extraction from the car - the Integra models
General information
Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
Removal and installation of a cover of a head of cylinders
Removal and installation of the inlet pipeline
Removal and installation of a final collector
Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
Replacement of a forward epiploon of a cranked shaft
VTEC systems - the general information and check of a condition of components
Removal, check of a condition and installation of camshafts and assembly of yokes
Replacement of klapanny springs with plates and maslootrazhatelny caps
Removal and installation of a head of cylinders
Removal and installation of the pallet of a case of the engine
Removal, check of a condition and installation of the oil pump
Flywheel replacement / driving disk
Replacement of a back epiploon of a cranked shaft
Check of a condition and replacement of support of a suspension bracket of the power unit
+ General and major maintenance of the engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the pallet of a case of the engine Removal
|
|
1. Warm up the engine to normal working temperature, then merge from it engine oil and remove the oil filter (see. Head Routine maintenance).
2. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action! |
3. To Poddomkratta the car also establish it on props. Remove protection of a case.
4. Remove a reception pipe of system of production of the fulfilled gases (see. Head of the Power supply system and release).
|
|
5. Turn out bolts of fastening of the pallet to the engine block (see an accompanying illustration). |
6. Обстучав the pallet on perimeter a hammer with soft brisk for the purpose of destruction of a layer of hermetic, separate it from the block (at all do not make attempts to hook the pallet under an interfaced surface).
7. Scratch out from interfaced surfaces of the pallet and the block all traces of hermetic and a material of old laying. Remove from the pallet or the block face sealing inserts. Carefully wipe interfaced surfaces the rags moistened in acetone. Clean and dry carving openings in the block. |
|
Installation
|
|
1. Wash out the pallet solvent and carefully dry it. Make sure of absence of deformations of an adjusting flange of the pallet, in case of need lay the pallet a flange on the flat wooden block and make a rikhtovka.
2. Impose on a prokladochny surface of a flange of the pallet a RTV hermetic pillow in thickness of 3 mm. Track, that hermetic was imposed from the interior of boltovy openings.
3. Accurately press the pallet to the block.
4. Screw bolts and in stages (on 1/4 turns for an approach) tighten them with demanded effort (see. Specifications). Begin a tightening with the bolt next to the center and move on a spiral outside. Remember that pulling of fixture is fraught with development of leaks.
5. Fill in engine oil (see. Head Routine maintenance), start the engine and check the pallet on existence of leaks. |
|
|
|
