Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
- Brake system
Specifications
System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
Replacement of brake shoes of disk brake mechanisms
Removal, repair and installation of supports of disk brake mechanisms
Condition check, removal and installation of a brake disk
Replacement of boots of drum-type brake mechanisms of back wheels
Removal and installation of wheel cylinders
Removal and installation of the main brake cylinder
Check of a condition and replacement of brake lines and hoses
Pumping of brake system
Check of serviceability of functioning/tightness, removal and installation of assembly of the vacuum amplifier of brakes
Adjustment of the parking brake
Cable replacement (ов) drive of the parking brake
Check of serviceability of functioning, replacement and adjustment of the sensor switch of stoplights
Check of serviceability of functioning and replacement of the sensor switch of level of brake liquid
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Cable replacement (ов) drive of the parking brake
Components of a drive of the parking brake
|
|
1. The scheme of an arrangement of components of the parking brake is presented on an accompanying illustration. Prop up protivootkatny boots forward wheels, weaken nuts of fastening of back wheels, then поддомкратьте a back of the car and establish it on props.
2. On the models equipped with drum-type brake mechanisms of back wheels, remove a brake drum (ы) (see. Replacement of boots of drum-type brake mechanisms of back wheels).
3. Weaken an adjusting nut on equalizer assembly (see. Adjustment of the parking brake). Remove from a cable cover intermediate clamps (see an illustration above).
|
|
4. On models with drum-type brake mechanisms of back wheels remove bashmachny assembly (see. Replacement of boots of drum-type brake mechanisms of back wheels) also disconnect a driving cable of the parking brake from the executive lever on a back boot (see an illustration). Wring out lock uvulas on the holder of a cover of a cable and pull out assembly of last of a brake board. |
5. On models with disk brake mechanisms of back wheels for a cable detachment from the executive lever it is necessary to remove a clip and to take a pin of fixing of a cutting finger (see an illustration to paragraph 4). The cover of a cable is in addition fixed in an arm by a spring clamp.
6. To Otboltita arms of intermediate clamps of fastening of a cable of a drive of the parking brake to the car bottom. Remove a cable, remembering a route of its laying.
|
|
Probably, it is necessary to turn out also bolts of fastening of the back thermofilter of system of production of the fulfilled gases. |
7. In case of need remove the second driving cable, operating in a similar manner.
8. Installation is made upside-down. Do not forget to execute adjustment of a drive of the parking brake. |
|
|
|
