Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
- Brake system
Specifications
System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
Replacement of brake shoes of disk brake mechanisms
Removal, repair and installation of supports of disk brake mechanisms
Condition check, removal and installation of a brake disk
Replacement of boots of drum-type brake mechanisms of back wheels
Removal and installation of wheel cylinders
Removal and installation of the main brake cylinder
Check of a condition and replacement of brake lines and hoses
Pumping of brake system
Check of serviceability of functioning/tightness, removal and installation of assembly of the vacuum amplifier of brakes
Adjustment of the parking brake
Cable replacement (ов) drive of the parking brake
Check of serviceability of functioning, replacement and adjustment of the sensor switch of stoplights
Check of serviceability of functioning and replacement of the sensor switch of level of brake liquid
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of wheel cylinders
|
|
In case of leaks wheel cylinders are subject to replacement without fail. Manufacturers do not recommend to undertake attempt of carrying out regenerative repair of these knots of brake mechanisms. |
Removal
|
|
1. To Poddomkratta a car back also establish it on props. Prop up forward wheels protivootkatny boots.
2. Remove a brake drum and boots (see. Replacement of boots of drum-type brake mechanisms of back wheels).
3. Clear the wheel cylinder and surfaces surrounding it of dirt.
|
|
4. Disconnect the hydraulic line from a back part of the wheel cylinder (see an accompanying illustration). In order to avoid a rounding off шлицов the union use a special cap natural a cutting head. At a detachment do not pull for a metal tube of the brake line in order to avoid its deformation, capable it is essential to complicate connection procedure. At once закупорьте the open end of the brake line for the purpose of minimization of losses of liquid and in order to avoid hit in hydraulic system of dirt. |
5. Give two bolts of fastening of the wheel cylinder (see an illustration above).
6. Remove the wheel cylinder from a brake board and transfer it on a pure workbench.
|
|
If on frictional overlays of brake boots there are traces of hydraulic liquid, it is necessary to replace boots, and a working surface of a drum carefully to smooth out. |
|
|
Installation
|
|
1. Grease interfaced surfaces of the wheel cylinder and a brake board with RTV hermetic. Establish the cylinder on the regular place and connect to it the hydraulic line. Do not tighten while a shtutserny nut.
2. Screw fixing bolts and strongly them tighten. Now it is possible to tighten a shtutserny nut finally. Establish into place bashmachny assembly.
3. Pump over brake system (see. Pumping of brake system).
4. Before starting car operation, make sure of serviceability of functioning of brakes. |
|
|
|
