Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
- Cooling and heating systems
   Specifications
   Antifreeze - general information
   Check of serviceability of functioning and thermostat replacement
   Check of a condition of the fan (ов) systems of cooling and chain of its inclusion, fan replacement (ов)
   Removal and installation of a radiator and broad tank of system of cooling
   Removal and installation of a maslookhladitel
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of the driving electromotor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of the electromotor of a drive of the fan of a heater
   Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable
   Replacement of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of the coupling of coupling of the To/in compressor
   Removal and receiver dehumidifier installation To/in
   Removal and To/in compressor installation
   Removal and To/in condenser installation
   Removal and To/in evaporator installation with the broad valve
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Replacement of the heat exchanger of a heater

Cars considered in the real Management are equipped with system of additional safety of SRS which is better known as a safety cushion. Before performing any works near assembly of a pillow or a steering column, without fail disconnect system in order to avoid receiving traumas as a result of its casual operation (see. Head Onboard electric equipment).

Air central air constantly is under a high pressure. At all do not disconnect refrigerator lines and do not remove any components of system, previously without having executed a discharge of the last. The discharge of central air of air should be made by strengths of the skilled expert in the conditions of a car-care center workshop. At a rassoyedineniye of refrigerator lines surely put on goggles!


 PERFORMANCE ORDER

1. If the car is equipped To/in, make a system discharge in the conditions of a specialized workshop. Disconnect a negative wire from the battery. Disconnect a safety cushion (see. Head Onboard electric equipment).

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!


2. Empty cooling system (see. Head Routine maintenance).

3. Disconnect a driving cable of the valve of a heater (see an accompanying illustration).

4a. In an impellent compartment disconnect hoses of an okhladitelny path of the engine from inlet and final branch pipes of the heat exchanger of a heater on a back partition of an impellent compartment (see an accompanying illustration).

4b. For collecting spilled liquid get under branch pipes drain capacity. Give a nut of assembly of the heater, located directly over inlet and final heat exchanger branch pipes on a back partition of an impellent compartment (see an accompanying illustration).


Try not to bend and otherwise not to damage the fuel lines laid near a nut and brake tubes.


5. On the Integra models remove a basic frame of a passenger safety cushion (see an accompanying illustration).

6. Remove assembly of management by functioning of the heater/conditioner of air (see. Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable).
7. Remove facing of an instrument guard, the console and an instrument guard (see. Head Body).
8. On models without To/in remove the sleeve of an air line located between blocks of a heater and its fan. On equipped In models remove also the evaporator block (see. Removal and To/in evaporator installation with the broad valve).
9. Remove an arm of a steering column.

10. Remove from the heater block a clamp of a plait of electroconducting, give two fixing nuts (see an accompanying illustration) and take the block from the car.

11. Turn out two screws from a cover of the heat exchanger of a heater and remove a branch pipe collar. Take the heat exchanger from a casing.
12. Installation is made upside-down. Do not forget to check serviceability of functioning of managing directors a zaslonok. In case of need make necessary regenerative repair, having replaced the broken or deformed components.
13. Fill system of cooling and remove from it air jams (see. Head Routine maintenance). Connect the battery and start the engine. Check components of system of heating on existence of signs of leaks and serviceability of functioning. At the corresponding complete set make a charging of central air of air in the conditions of a specialized workshop.