Honda Civic/Acura Integra

since 1994 of release

Repair and car operation



Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
- Cooling and heating systems
   Specifications
   Antifreeze - general information
   Check of serviceability of functioning and thermostat replacement
   Check of a condition of the fan (ов) systems of cooling and chain of its inclusion, fan replacement (ов)
   Removal and installation of a radiator and broad tank of system of cooling
   Removal and installation of a maslookhladitel
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of the driving electromotor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of the electromotor of a drive of the fan of a heater
   Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable
   Replacement of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of the coupling of coupling of the To/in compressor
   Removal and receiver dehumidifier installation To/in
   Removal and To/in compressor installation
   Removal and To/in condenser installation
   Removal and To/in evaporator installation with the broad valve
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Removal and installation of a maslookhladitel

Before starting procedure performance, wait complete cooling of the engine.


 PERFORMANCE ORDER

1. On some Integra models between the polnopotochny oil filter and the block of the engine the maslookhladitel (see an accompanying illustration) is established.

2. Remove the oil filter and merge impellent oil (see. Head Routine maintenance).
3. Disconnect from a maslookhladitel two lines of an okhladitelny path. Prepare for collecting spilled liquid. At once закупорьте open ends of lines and shtutserny connections.
4. Give a big nut (usually representing part of a hollow fixing bolt) in the center of a maslookhladitel and separate the last from the engine.
5. Installation is made upside-down. Do not forget to replace the sealing ring established between the block and a maslookhladitel (before installation grease a new ring with pure impellent oil). Track reliability of fastening of hoses of okhladitelny lines on the unions.
6. Establish the new oil filter and fill in in the engine fresh engine oil (see. Head Routine maintenance).
7. Necessarily correct levels of cooling liquid and impellent oil.
8. Start the engine and check it on existence of signs of leakages of oil or cooling liquid.
9. Once again check levels of oil and cooling liquid.