Honda Civic/Acura Integra

since 1994 of release

Repair and car operation

Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
- Cooling and heating systems
   Specifications
   Antifreeze - general information
   Check of serviceability of functioning and thermostat replacement
   Check of a condition of the fan (ов) systems of cooling and chain of its inclusion, fan replacement (ов)
   Removal and installation of a radiator and broad tank of system of cooling
   Removal and installation of a maslookhladitel
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of the driving electromotor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of the electromotor of a drive of the fan of a heater
   Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable
   Replacement of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of the coupling of coupling of the To/in compressor
   Removal and receiver dehumidifier installation To/in
   Removal and To/in compressor installation
   Removal and To/in condenser installation
   Removal and To/in evaporator installation with the broad valve
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and To/in evaporator installation with the broad valve

Air central air constantly is under a high pressure. At all do not disconnect refrigerator lines and do not remove any components of system, previously without having executed a discharge of the last. The discharge of central air of air should be made by strengths of the skilled expert in the conditions of a car-care center workshop. At a rassoyedineniye of refrigerator lines surely put on goggles!

Cars considered in the real Management are equipped with system of additional safety of SRS which is better known as a safety cushion. Before performing any works near assembly of a pillow or a steering column, without fail disconnect system in order to avoid receiving traumas as a result of its casual operation (see. Head Onboard electric equipment).

PERFORMANCE ORDER

1. Make a discharge of central air of air in the conditions of a specialized workshop.
2. Disconnect a negative wire from the battery. Disconnect a safety cushion.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

3. Turn out bolts and disconnect from the evaporator two refrigerator lines (see an accompanying illustration). At once закупорьте the open ends of lines and unions in order to avoid hit in dirt system.

4. Remove a ware box (see. Head Body).
5. Disconnect electroconducting from the To/in thermostat and remove clamps of a plait of wires from an evaporator casing.

6. Give fixture (see an accompanying illustration), disconnect from assembly a drainage hose and remove the evaporator from the car.

7a. Turn out forward fixing screws.

7b. Turn out back fixing screws, release clamps (see accompanying illustrations) and divide an evaporator casing into two half, previously having removed from it the К/В thermostat.

8. Take from a casing the evaporator heat exchanger, in case of need remove the broad valve.
9. Make a system charging in a specialized workshop.