Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
- Cooling and heating systems
   Specifications
   Antifreeze - general information
   Check of serviceability of functioning and thermostat replacement
   Check of a condition of the fan (ов) systems of cooling and chain of its inclusion, fan replacement (ов)
   Removal and installation of a radiator and broad tank of system of cooling
   Removal and installation of a maslookhladitel
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of the driving electromotor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of the electromotor of a drive of the fan of a heater
   Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable
   Replacement of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of the coupling of coupling of the To/in compressor
   Removal and receiver dehumidifier installation To/in
   Removal and To/in compressor installation
   Removal and To/in condenser installation
   Removal and To/in evaporator installation with the broad valve
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Check of an electric chain of the coupling of coupling of the To/in compressor

1a. At refusal of inclusion of coupling of the compressor first of all it is necessary to remove the corresponding relay and to check its condition (see accompanying illustrations). Arrangement of plugs of the relay (Civic model).

1b. An arrangement of plugs of the relay (the Integra model for 1997 вып.).

1с. An arrangement of plugs of the relay (the Integra model since 1998 вып.).


2. If the relay as it should be, make sure available tension between plugs of its reception nest and weight, having checked thereby serviceability of giving of a food to the relay. If tension is absent, therefore, break in a chain which it is necessary to find and eliminate takes place.
3. Having made sure of serviceability of giving of a food to the relay, establish a wire crossing point between (Civic model) plugs 1 and 3, And and With (the Integra models till 1997 вып.) or 1 and 2 (Integra since 1998 вып.) relay nests – the distinct click testifying to operation of the coupling of coupling of the compressor should be distributed.

4. If the coupling does not work (there is no click), remove a wire crossing point, disconnect from the coupling electroconducting and check conductivity existence between a red wire of its socket and the compressor (see an accompanying illustration). In case of need eliminate break. In the presence of conductivity check serviceability of a condition of the coupling.

5. Disconnect the sensor switch of pressure of a low pressure To/in and, at the included ignition, make sure available tension of the battery between the plug 1 (Civic – the plug of a dark blue-white wire), or 2 (Integra – the plug of a blue-red wire) and weight. Lack of tension testifies break existence. Otherwise switch off ignition and make sure available conductivity between plugs of the sensor switch. If conductivity is absent, check the sensor switch and pressure in system.