|
|
Honda Civic/Acura Integrasince 1994 of releaseRepair and car operation |
|
|
Honda Tsivik + Honda Civic and Acura Integra brand Cars + Maintenance instruction + Routine maintenance + Engine - Cooling and heating systems Specifications Antifreeze - general information Check of serviceability of functioning and thermostat replacement Check of a condition of the fan (ов) systems of cooling and chain of its inclusion, fan replacement (ов) Removal and installation of a radiator and broad tank of system of cooling Removal and installation of a maslookhladitel Check of a condition of the water pump Replacement of the water pump Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid Check of serviceability of functioning of the driving electromotor of the fan of a heater and condition of components of its electric chain, replacement of components Removal and installation of the electromotor of a drive of the fan of a heater Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable Replacement of the heat exchanger of a heater Check of serviceability of functioning and service of systems of heating and air conditioning Check of an electric chain of the coupling of coupling of the To/in compressor Removal and receiver dehumidifier installation To/in Removal and To/in compressor installation Removal and To/in condenser installation Removal and To/in evaporator installation with the broad valve + Power supply system and release + engine Electric equipment + Control systems of the engine + gear shifting Box + clutch and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment 
|
Antifreeze – general information
For filling of system of cooling the mix of antifreeze made in due proportions on base этиленгликоля with soft water is usually used. The mix should show stability to freezing at temperatures to – 30°С, and at need and below, depending on a climatic belt of an arrangement of the region of operation of the car. Except frost resistance, antifreeze gives mixes anticorrosive properties and raises a point of its boiling. Oporozhneniye and washing of system of cooling should be made according to the schedule of routine maintenance of the car (see. Head Routine maintenance). Use of cooling liquid during longer term is fraught with different damages of system, development of corrosion and scaling. If tap water in the region where the car is maintained, is "rigid", i.e. differs the raised content of mineral salts, for formation of cooling liquid it is necessary to use the distilled or rain water. Before adding cooling liquid in system check reliability of fastening of its hoses on the unions – antifreeze possesses high fluidity and is capable to escape through the slightest thinnesses. During normal operation of the engine cooling liquid is not spent, therefore falling of its level is a sign of development of the external leaks which reason should be immediately found out and eliminated. The exact composition of cooling liquid is defined by specific climatic conditions. Thus the content of antifreeze in a mix should not be lower than 50 % and not exceed 70 % – address to the card of composition of cooling liquid (see. Head Routine maintenance). Areometers for determination of specific weight (density) of cooling liquid can be got practically in any shop of automobile accessories. Try to use only recommended by manufacturers of the car of a grade of antifreeze (see. Specifications). |
|