Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
- clutch and power shafts
Specifications
Coupling - the general information and check of a condition of components
Removal and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Air removal from a hydraulic path of a drive of switching off of coupling
Removal, check of a condition and installation of components of assembly of coupling
Check of a condition and replacement of the directing bearing
Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
Adjustment of a pedal of coupling
Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
Removal and installation of power shafts
Removal and installation of an intermediate shaft (Integra model)
Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of an intermediate shaft (Integra model)
Removal
|
|
1. Weaken nuts of fastening of the left forward wheel. To Poddomkratta a car front also establish it on props. Remove a wheel.
2. Merge transmission oil (see. Head Routine maintenance).
3. Liberate the bottom control lever of a suspension bracket from a rotary fist (see. Head Suspension bracket and steering).
4. Having hooked the lever for a casing, liberate a pin of the internal CV JOINT from assembly of an intermediate shaft. Take a power shaft aside and tie up it a wire to a suspension bracket element (at all do not leave a power shaft hanging on the external CV JOINT!).
|
|
5. Turn out three bolts of fastening of a support of the bearing of an intermediate shaft to the engine block (see an accompanying illustration). Take a shaft from transmission, – try not to damage a differential epiploon. |
6. Check freedom of rotation of the basic bearing (holding the bearing rotate a shaft). In case of identification of breakthroughs and jamming points it is necessary to deliver assembly of a shaft in a car-care center workshop as for replacement of the bearing it is made by means of the special tool. |
|
Installation
|
|
1. Grease epiploon sponges in a case of transmission with universal greasing. Accurately fill a pin of an intermediate shaft in a nest of a lateral gear wheel of differential. Screw bolts of fastening of a support of the bearing and tighten from with demanded effort.
2. Establish a new spring lock ring on a pin of the internal CV JOINT of a power shaft (see illustrations 1а and 1b), then fill a pin in assembly of an intermediate shaft.
3. Connect the bottom lever of a suspension bracket in a rotary fist, tighten with demanded effort (see. Specifications to Head the Suspension bracket and a steering) a nut of a finger of a spherical support.
4. Establish a wheel, lower the car on the earth and tighten nuts of fastening of a wheel with demanded effort (see. Specifications to Head Routine maintenance).
5. Fill in in transmission necessary amount of oil of a demanded grade (see. Head Routine maintenance). |
|
|
|
