Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
- clutch and power shafts
   Specifications
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Check of a condition and replacement of the directing bearing
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft (Integra model)
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Adjustment of a pedal of coupling

Details of adjustment of a pedal of coupling

1 — a sensor switch A Lock-nut
2 — the Sensor switch A
3 — a sensor switch B Lock-nut
4 — the Sensor switch In disconnections of a chain of a starter
5 — the Auxiliary spring
6 — the Main cylinder of coupling

7 — the Lock-nut of a pusher of the main cylinder
8 — the Full speed of a pedal of coupling
9 — the Free wheeling of a pedal of coupling
10 — Height of a pedal of coupling
11 — Height of the squeezed-out pedal of coupling

Pedal height

The distance from its slip to the floor panel (see an accompanying illustration) is called as height of provision of a pedal. If the result of measurement of this distance falls outside the limits an admissible range, it is necessary to make the corresponding adjustment.

 PERFORMANCE ORDER

1. For adjustment of provision of a pedal weaken a lock-nut of the sensor switch of coupling (And) or an adjusting bolt and turn out the switch so that it ceased to adjoin to a pedal. Now weaken a pusher lock-nut (see an illustration above) and, rotating the last, correct in a demanded way height of provision of a pedal. Tighten a lock-nut.
2. Rotating a sensor switch/bolt clockwise, bring it into contact to the pedal lever, then tighten on 3/4 turn/turn. Tighten a lock-nut.
3. Adjust the sensor switch of disconnection of a chain of a starter (see. Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter).

Free wheeling of a pedal

The distance on which the pedal moves is called as a free wheeling, without meeting resistance and without causing coupling operation (see an illustration above). At an exit of size of a free wheeling of a pedal out of limits of an admissible range it is necessary to make the corresponding adjustment.

 PERFORMANCE ORDER

1. For adjustment of a free wheeling weaken a lock-nut on a pedal pusher, then, rotating a pusher, achieve demanded result. Tighten a lock-nut.
2. Make sure of correctness of adjustment of the sensor switch of disconnection of a chain of a starter (see. Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter)