Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
- clutch and power shafts
   Specifications
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Check of a condition and replacement of the directing bearing
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft (Integra model)
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Check of a condition and replacement of the directing bearing

As the directing bearing of coupling the ball-bearing pressed in a flywheel is used. The bearing is executed tight and filled by greasing at manufacturer. A problem of the bearing is fixing of the forward end of a pin of primary shaft of a transmission. Check of a condition of the bearing should be made each time at removal of coupling from the engine. In view of the inaccessibility the directing bearing should be changed at the slightest doubts in an assessment of its condition.

If the engine is removed from the car and the assembly stand is established on a workbench/, the procedures described in the following paragraphs should be lowered.


 PERFORMANCE ORDER

1. Remove a transmission (see a 5-step manual box of gear shifting).
2. Remove coupling components (see. Removal, check of a condition and installation of components of assembly of coupling).
3. By means of a small lamp survey the bearing on existence of signs of excessive wear, signs of drying of greasing, cracks, задиров and other mechanical damages. In case of this sort of detection of defects replace the bearing.

4. Extraction of the bearing can be made by means of a small stripper with sliding cargo (see an accompanying illustration).

5. In the absence of near at hand stripper remove a flywheel (see. Engine repair without extraction from the car - the Civic models), then by means of a hammer and a drift beat out the bearing from the landing nest (knocking-out make forward from the back party of a flywheel).

6. Before installation of the new bearing slightly grease it outside with greasing. As an opravka the face head will be suitable for landing of the bearing, diameter slightly less external diameter of the bearing (see an accompanying illustration).

7. Establish into place a flywheel (see. Engine repair without extraction from the car - the Civic models). Establish coupling assembly, a transmission and other components acting in film for the purpose of ensuring access. All fixture tighten with the corresponding effort.