Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
- clutch and power shafts
Specifications
Coupling - the general information and check of a condition of components
Removal and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Air removal from a hydraulic path of a drive of switching off of coupling
Removal, check of a condition and installation of components of assembly of coupling
Check of a condition and replacement of the directing bearing
Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
Adjustment of a pedal of coupling
Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
Removal and installation of power shafts
Removal and installation of an intermediate shaft (Integra model)
Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
|
|
Remember that developed in the course of wear of frictional overlays of a conducted disk of coupling the dust can contain unhealthy asbestos. Do not blow off a dust the compressed air and try not to inhale it. Do not apply to rubbing of components of coupling solvents on an oil basis, – use only special brake cleaners or pure methyl alcohol. The used rags put in tightly closed container. |
Removal
|
|
1. To Otboltita the executive cylinder of coupling (see. Removal and installation of the executive cylinder of coupling), without disconnecting from it the hydraulic line going from the main cylinder. Tie up the cylinder aside a wire.
2. Remove a transmission (see a 5-step manual box of gear shifting).
|
|
3. Remove from a pin of primary shaft vyzhimny the bearing, disconnect holding spring of a fork of switching off of coupling from a spherical finger of a spherical support and remove a fork (see an accompanying illustration). |
|
|
Check
|
|
|
|
1. Holding the bearing for an external holder, press internal and повращайте it (see an accompanying illustration). The bearing should rotate freely and silently, otherwise it is necessary to replace it. |
2. Wipe the bearing pure rags and examine on existence of signs of wear, cracks and other mechanical damages. Usually replacement of the vyzhimny bearing is made each time at service of components of coupling. At all do not wash out the bearing in solvent in order to avoid violation of tightness of its assembly. Also check the lever of switching off of coupling on existence of cracks and signs of deformations. |
|
Installation
|
|
|
|
1. Fill an internal flute of the vyzhimny bearing refractory greasing. With the same greasing slightly grease shlitsa of a pin of primary shaft of a transmission and the holder of the bearing of the last (see an accompanying illustration). |
|
|
2a. With the same greasing grease a nest under landing of a spherical finger from a reverse side of a fork of switching off... |
|
|
2b.... and also a nest under landing of a pusher of the executive cylinder (see accompanying illustrations). |
|
|
2c. Grease a spherical finger of a spherical support of the lever of inclusion. |
3. Enter vyzhimny the bearing into gearing with a fork of switching off of coupling.
4. Put on the bearing on the holder of the forward bearing of primary shaft of a transmission, at the same time spending the end of a fork of switching off through an opening in a coupling casing. Densely plant a switching off fork on a sharovy finger of a spherical support.
5. Slightly grease with refractory greasing contacting to petals of a diafragmenny spring a surface of the vyzhimny bearing.
6. Further installation is made as it should be, the return to a dismantle order. |
|
|
|
