Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
- clutch and power shafts
   Specifications
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Check of a condition and replacement of the directing bearing
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft (Integra model)
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Air removal from a hydraulic path of a drive of switching off of coupling

Pumping of a hydraulic drive of switching off of system should be carried out each time after removal of its components and also when liquid level in the tank falls so that air gets to the main cylinder. A pumping principle the same, as used at air removal from a brake path.

 PERFORMANCE ORDER

1. Fill in in the main cylinder fresh brake DOT 3 liquid.

Do not use liquid repeatedly extorted from system, and also, liquid, a long time stored in leaky closed container.


2. To Poddomkratta the car also establish it on props, having provided normal access to the executive cylinder on a coupling dome.

3. Remove a dustproof cap and pull on the gate of pumping of the cylinder the end of a plastic hose suitable on the size (see an accompanying illustration). The second end of a hose lower in capacity partially filled with brake liquid with transparent walls. Track, that the cut of a hose appeared entirely is shipped in liquid.

4. Ask the assistant to squeeze out a pedal of coupling and to fix it in we string situation. Open the gate of pumping and let out from the cylinder liquid in drain capacity. When the effluence of the liquid mixed with air bubbles will stop, again densely tighten the gate and allow to release to the assistant a pedal.
5. Continue pumping in the same manner until leaving the cylinder completely it will not be released from air bubbles. Constantly watch closely liquid level in the tank of the main cylinder, without allowing its excessive lowering, air dangerous by hit to the highway and data to zero of all undertaken efforts.
6. Having finished pumping, disconnect a hose and establish into place a dustproof cap. Lower the car on the earth and check serviceability of functioning of coupling.