Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
- clutch and power shafts
   Specifications
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Check of a condition and replacement of the directing bearing
   Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft (Integra model)
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Removal and installation of the executive cylinder of coupling

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!


2. To Poddomkratta the car also establish it on props.

3. A special cap key weaken a shtutserny nut and disconnect from the executive cylinder the hydraulic line (see an accompanying illustration). Prepare for collecting spilled liquid. At once закупорьте the open ends of the line and shtutserny connection in order to avoid hit in dirt system.

4. Turn out two fixing bolts (see an accompanying illustration).

5. Remove the executive cylinder.

Installation

 PERFORMANCE ORDER

1. Establish the executive cylinder on the regular place on a coupling dome, by hand tighten fixing bolts. Track correctness of landing of a pusher in a pocket of a fork of switching off of coupling.
2. Connect to the cylinder the hydraulic line, then finally tighten fixing bolts. A special cap key strongly tighten a shtutserny nut.
3. Fill in in the cylinder necessary amount of brake DOT 3 liquid.
4. Pump over hydraulic system (see. Air removal from a hydraulic path of a drive of switching off of coupling).
5. Lower the car on the earth and connect a negative wire to the battery.