Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
- clutch and power shafts
Specifications
Coupling - the general information and check of a condition of components
Removal and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Air removal from a hydraulic path of a drive of switching off of coupling
Removal, check of a condition and installation of components of assembly of coupling
Check of a condition and replacement of the directing bearing
Removal, check of a condition and installation of the vyzhimny bearing and fork of switching off of coupling
Adjustment of a pedal of coupling
Condition check, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
Removal and installation of power shafts
Removal and installation of an intermediate shaft (Integra model)
Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the main cylinder of coupling
Removal
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action! |
2. Under the dashboard take a pin and disconnect from a coupling pedal a cutting finger of a pusher of the main hydraulic cylinder.
|
|
3a. Disconnect the tank of the main cylinder of coupling (see an accompanying illustration). |
|
|
3b. Самоконтрящимися nippers press the submitting hose connecting the tank to the main cylinder (see an accompanying illustration). |
|
|
Hose it is necessary to press at distance about 5 cm from the cylinder of a cut tense on the union. |
|
|
4. Disconnect from the main cylinder hydraulic lines (see an accompanying illustration). For the purpose of minimization of losses of hydraulic liquid wind shtutserny knots with rags. At once закупорьте the open ends of lines and unions in order to avoid hit in dirt system. |
|
|
In order to avoid damage of a paint and varnish covering do not allow hit of hydraulic liquid on the painted surfaces of body panels. |
|
|
5. In car salon under the dashboard give two nuts of fastening of the main cylinder to a partition of an impellent compartment (see an accompanying illustration). Remove the cylinder from the car. |
|
|
Installation
|
|
1. Get the main cylinder on the regular place and fix it bolts, having by hand tightened nuts of the last.
2. Restore initial connection of hydraulic lines. In case of need slightly correct position of the cylinder for the purpose of simplification of a nazhivleniye of the union of the pressure head line. Tighten a collar of fastening of a submitting hose.
3. Strongly tighten fixture and the union of the hydraulic line.
4. Connect a pusher to a pedal of coupling and fix a new pin a cutting finger.
5. Remove the nippers pressing submitting hose. Fill in in the tank necessary amount of brake DOT 3 liquid (see. Head Routine maintenance), then give from a path air jams (see. Air removal from a hydraulic path of a drive of switching off of coupling). |
|
|
|
