Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
- Maintenance instruction
Arrangement and functions of governing bodies
Keys and locks
Adjustment of seats
The equipment and governing bodies in salon
Heater and air conditioner
Control system of a salon microclimate
Audiosystem
Safety systems
Running in of the new car
Cowl unlocking
The valve of shutdown of supply of fuel in case of failure (on some models)
Engine start
Five-step manual box of gear shifting
Automatic transmission
Besstupenchaty variator (separate models)
Devices of external lighting and trailer alarm system
Check of level of liquid in automatic transmission
Driving belts
Emergency closing of the panel of the hatch of a roof
Safety locks
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Engine start
|
|
1. Cock the parking brake.
2. At low temperature of air switch off everything auxiliary consumers of electric energy to reduce loading of the storage battery.
3. Cars with a manual transmission with manual switching: Completely switch off coupling, having pressed a pedal against the stop, and transfer the gear shifting lever to neutral situation. Cars with automatic transmission (including a besstupenchaty variator):
Check, that the lever of the selector of ranges was in the situation Park (Parking). Press a brake pedal.
4. Without pressing an accelerator pedal, turn a key in the ignition lock in situation III (START-Starter) and include a starter. If the engine was not started at once, continue to scroll a cranked shaft a starter, but duration of continuous inclusion of a starter should not exceed 15 seconds. Before making repeated attempt to start the engine, make the pause not less than 10 seconds necessary for cooling of a starter.
5. If the engine is not started at continuous work of a starter within 15 seconds or starts to work and at once stops, try to start the engine (see operation 4), having pressed an accelerator pedal to a half of its full speed. After successful start of the engine release an accelerator pedal to avoid sharp increase of frequency of rotation of a cranked shaft of the engine idling.
6. If the engine still does not manage to be started, completely press a pedal of an accelerator and hold her in the pressed situation in starter operating time. It will help to remove the superfluous fuel which has got to the inlet pipeline and cylinders of the engine. Duration of continuous work of a starter, as well as in the previous cases, should not exceed 15 seconds. If the engine is not started after a purge of cylinders, once again try to start it by partial pressing an accelerator pedal (see operation 5). After successful start of the engine release an accelerator pedal to avoid sharp increase of frequency of rotation of a cranked shaft of the engine idling. |
|
Features of start of the engine in cold weather in the conditions of highlands (height above sea level more than 2400 m) At low temperature of air start of the engine is at a loss. In the conditions of highlands where air is strongly discharged, start of the engine becomes complicated in addition.
At engine start:
|
|
1. Switch off everything auxiliary consumers of electric energy to reduce loading of the storage battery.
2. Press an accelerator pedal to a half of its full speed and hold her in this situation during a prokruchivaniye of a cranked shaft of the engine a starter. Duration of continuous inclusion of a starter should not exceed 15 seconds. After successful start of the engine gradually release an accelerator pedal, without allowing substantial increase of frequency of rotation of a cranked shaft of the engine idling.
3. If the engine is not started, completely press a pedal of an accelerator and hold her in the pressed situation in starter operating time. Duration of continuous work of a starter, as well as in the previous case, should not exceed 15 seconds. If the engine still is not started, once again try to start it by partial pressing an accelerator pedal (see operation 2). |
|
At negative temperature of air or if the car was not used some days, let's to the engine get warm about a current of 3-4 minutes before beginning movement. |
|
