Honda Civic/Acura Integra

since 1994 of release

Repair and car operation



Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
- Maintenance instruction
   Arrangement and functions of governing bodies
   Keys and locks
   Adjustment of seats
   The equipment and governing bodies in salon
   Heater and air conditioner
   Control system of a salon microclimate
   Audiosystem
   Safety systems
   Running in of the new car
   Cowl unlocking
   The valve of shutdown of supply of fuel in case of failure (on some models)
   Engine start
   Five-step manual box of gear shifting
   Automatic transmission
   Besstupenchaty variator (separate models)
   Devices of external lighting and trailer alarm system
   Check of level of liquid in automatic transmission
   Driving belts
   Emergency closing of the panel of the hatch of a roof
   Safety locks
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ Cцепление and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Emergency closing of the panel of the hatch of a roof

At refusal of an electric drive of the hatch of a roof execute the following.

 PERFORMANCE ORDER

1. Check serviceability of the fuse of the electric motor of a drive of the hatch of a roof, see. Section Safety locks. If the safety lock burned down, replace it with the serviceable safety lock calculated on the same or smaller size of rated current.
2. Try to close the panel of the hatch of a roof. If the new safety lock fuses at once or the electric motor still does not work, you can close the hatch manually.
3. Get from a luggage carrier a tool set.

4. By means of a screw-driver or a coin remove a round cap which is located on a ceiling and closes a turnkey nest.

5. Insert the cut end of a cranked key into a nest of the coupling of a drive of the hatch of a roof. Rotating the key handle clockwise, completely close the roof hatch.


6. Take out a key from a nest of the coupling and establish a cap into place.