Honda Civic/Acura Integra

since 1994 of release

Repair and car operation



Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
- Maintenance instruction
   Arrangement and functions of governing bodies
   Keys and locks
   Adjustment of seats
   The equipment and governing bodies in salon
   Heater and air conditioner
   Control system of a salon microclimate
   Audiosystem
   Safety systems
   Running in of the new car
   Cowl unlocking
   The valve of shutdown of supply of fuel in case of failure (on some models)
   Engine start
   Five-step manual box of gear shifting
   Automatic transmission
   Besstupenchaty variator (separate models)
   Devices of external lighting and trailer alarm system
   Check of level of liquid in automatic transmission
   Driving belts
   Emergency closing of the panel of the hatch of a roof
   Safety locks
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

The equipment and governing bodies in salon

CARS WITH THE 3-DOOR BODY THE HATCHBACK


To increase the used volume of a luggage compartment, you can remove the back shelf.

On some updatings of the car it is necessary to disconnect previously flexible drafts from hooks on a back door.


At first combine a back part of the shelf on a lobby.

Then lift the combined shelf up and release it from clamps. To establish the back shelf on a place, place it so that thorns of clamps were over the corresponding grooves, then press the shelf from above.


Thorns should enter and be fixed. Check reliability of assembly of clamps that the shelf was not displaced under way the car. In the presence of flexible drafts attach them to the corresponding hooks on a back door. For this purpose it is necessary to cover a door partially previously.

CARS WITH THE 5-DOOR BODY THE HATCHBACK


To dismantle from the car the back shelf, remove rings of flexible drafts from hooks on a back door and, having pulled the shelf on, release it from clamps.

Electroheating of seats (separate models)


Both lobbies of a seat are equipped with electric heaters which can work only at the included ignition (the ignition key will turn in situation II). Press the switch button to warm up a seat. At the same time on the pressed button the indicator of inclusion of electroheating will light up. By repeated pressing the same button the electroheating of a seat will be switched off. The burning indicator reminds that the electroheating of a seat is included.

Do not include electroheating of seats at the idle engine, and do not use electroheating long time at operation of the engine idling. It can lead to the strong category of the storage battery and difficulties at engine start.

Regulator of the direction of optical axes of light of headlights (separate models)


On the car possibility of adjustment of the direction of light of headlights (passing beam) in the vertical plane is provided. Depending on number of passengers and cargo existence in a luggage carrier you can correct the provision of headlights to provide the best conditions of illumination of the road and not to blind drivers of counter cars.

Switch the handle of a regulator of headlights in one of four provisions which corresponds to option of loading of the car.

Situation 0: One driver or the driver and the passenger on a forward seat.

Situation 1: Driver and four passengers.

Situation 2: The driver and four passenger, cargo in a luggage carrier (within the full resolved weight of the car).

Situation 3: The driver and cargo in a luggage carrier (within the most permissible load on an axis and the full resolved weight of the car).

Electric window regulators (separate models)

Your car is equipped with electric window regulators which can work only at the included ignition (the ignition key will turn in situation II).

On each door the switch intended for management of an electric window regulator of this door is located. To open a window, press down the button of the switch and hold her in the pressed situation in process of lowering of glass. You can stop glass in desirable situation, having released the button. Lifting of glass is carried out if to shift the button back and to hold her in this situation.


On an armrest of a driver's door the central control panel is located all electric window regulators. To open a window of any passenger door, press down the button of the corresponding switch and hold it pressed in the course of glass lowering before desirable situation. For lifting of glass shift the corresponding button back and hold her in this situation. When glass will occupy demanded situation, release the button.

On the central control panel electrowindow regulators are located also the switch of a window regulator of a driver's door which can work in the automatic AUTO mode, and the switch of blocking of electrowindow regulators of passenger doors.

AUTO mode (Automatic)

Glass of a driver's door can be completely lowered and lifted (on some updatings of the car) at single impact on the switch button. For lowering or glass lifting in an automatic mode press down or shift back against the stop the button of the switch of an electrowindow regulator. Thus the window will completely open or will be closed. You can stop at any time glass, having shifted the button back during lowering and having pressed the button down in the course of glass lifting. For partial lowering or lifting of glass of a driver's door slightly press down or shift back the button of the switch of an electrowindow regulator and hold its pressed during glass movement. Glass will stop, as soon as you release the switch button.

The SWITCH of BLOCKING allows the driver to disconnect a food of electrowindow regulators of passenger doors and to block management of window regulators by means of the switches located on passenger doors. Blocking does not affect a window regulator of a driver's door. Include blocking of electrowindow regulators of passenger doors if in the car children go. It will help to prevent a casual travmirovaniye of children.

CARS WITH THE 3-DOOR BODY THE HATCHBACK

On an armrest of a driver's door the main switch and two switches of electrowindow regulators of the left and right doors are located.

CARS WITH THE 5-DOOR BODY THE HATCHBACK

The switch of a window regulator of a driver's door is located in front of the handle of opening of a door. The main switch and switches of window regulators of other doors are on the central console about the lever of the parking brake.

The electric window regulator can strongly clamp and injure a children's hand or the fingers which have got to an aperture of a window. Before including an electric window regulator on window closing, check, that children cleaned hands from an aperture.

Roof hatch (separate models)


The switch of the electric drive of the panel of the hatch of a roof is located on the control panel. The drive of the panel of the hatch can function only at the included ignition (the ignition key will turn in situation II). To lift a back edge of the panel of the hatch for ensuring ventilation of salon, press the button with a symbol. The button is intended for moving of the panel of the hatch of a roof back. Press this button and hold its panel of the hatch pressed in the course of movement. The hatch will stop, as soon as you release the button. To close the panel of the hatch of a roof, press the button and hold it pressed to complete closing.

The electric drive of the panel of the hatch of a roof can strongly clamp and injure got to a hatch aperture a hand or fingers. Before pressing the button and to close the roof hatch, be convinced that the aperture in a roof is completely free also danger to clamp a hand or fingers someone from passengers is absent.


Attempt to open the roof hatch at negative temperature of air or if the hatch is covered with a snow layer or ice, can lead to damage of the hatch or its electric drive.

Rear-view mirrors


For providing the good review of a zone behind the car it is necessary to support constantly purity and to check пра

vilnost of adjustment internal and external rear-view mirrors. If necessary adjust rear-view mirrors before a trip on the car. The internal rear-view mirror can be in two provisions: for movement in day and in a night-time. In the second situation reflecting ability of a mirror decreases. It promotes weakening of blinding action of headlights of the cars going behind. The rychazhok located under a mirror is intended for mirror transfer from one situation in another.

Electric adjustment of rear-view mirrors (separate models)


Adjust the provision of external mirrors by means of the switch and the shaking key, located on the control panel to the left of a steering column, as follows.

 PERFORMANCE ORDER

1. Include ignition, having turned a key in the ignition lock in situation II.
2. Translate a switch rychazhok to the left (L) or to the right (R) to adjust the left or right mirror respectively.

3. Pressing the upper, bottom, left or right edge of a shaking key, adjust the chosen external mirror. Thus the mirror will turn rather horizontal and vertical axes in the relevant party.


4. After the completion of adjustment of both mirrors transfer a rychazhok to average situation in which the adjusting key does not operate. It is necessary in order that by casual pressing a shaking key not to break the established adjustment of an external mirror.

Folding of external rear-view mirrors (separate models)

For convenience of a parking of the car in the constrained conditions you can combine external rear-view mirrors. For management of folding of mirrors the switch close to an adjusting key serves.


Before a trip check, that external mirrors were returned into position. The electric drive of folding of external mirrors works only at the included ignition (a key will turn in the ignition lock in situation II). Press the button for simultaneous folding of both rear-view mirrors. To return mirrors into position, once again press the same button.


Never begin movement with the combined external rear-view mirrors.

Hours with digital indication


Hours with digital indication show the current time only at the included ignition. To establish on hours the current time, execute the following.

 PERFORMANCE ORDER

1. Include ignition, having turned a key in the ignition lock in situation II. Thus on the display there will be indications of hours and minutes.
2. Press and hold the button H until indications in the first two categories on the display will not accept (hours) the correct value corresponding to the current time.
3. Press and hold the button M until indications in the last two categories on the display (minute) will not accept the correct value corresponding to the current time.

The RESET button is intended for fast updating of indications of hours on signals of exact time. The pressing the RESET button leads to zeroing of categories of minutes and installation of hours for the beginning of the current or next hour. If since the beginning of the current hour passed more than 30 minutes, on hours time corresponding to the beginning of the next hour is established.

Example:

Initial indication of hours

The indication of hours after pressing the RESET button

1: 06

1: 00

1: 52

2: 00

Ware box


Open a cover of a ware box, having pulled for the handle on itself. To close a ware box, simply slam a cover.

CARS WITH THE 5-DOOR BODY THE HATCHBACK

The cover of a ware box is locked. To open a ware box, insert into the lock cylinder a key and turn it counter-clockwise. Locking of a ware box is made by key turn to the opposite side.

Holder of glasses (separate models)


To put forward the holder of glasses, press a forward level, as is shown in an illustration an arrow. The holder will come to light, then the cover will automatically lean back up. For return of the holder into place push it back in the panel before clamp click.

Use the holder of glasses only at stops. Under way the car drinks can be spilled, for example, at journey of road roughness or on turn.

Be careful when using the holder for glasses.


Splashes of the hot drink poured in glasses, can burn you or passengers. Besides, the spilled liquid can damage an upholstery of seats, floor rugs or the electric equipment which was nearby.

Tray for coins (for cars with the left wheel)


To open a tray for coins, press the upper edge of a cover of a tray, as is shown in an illustration an arrow. The tray is closed by pressing a cover before clamp click.

Office for personal belongings of the driver (separate models)


To open office for small personal belongings, press the upper edge of a cover, as is shown in an illustration an arrow. The office is closed by pressing a cover before clamp click.

CARS WITH THE 5-DOOR BODY THE HATCHBACK

In an armrest of the central console there is a small office for storage of small things. The office is closed by a cover thrown back back. Under a seat of the driver the sliding tray is located.

Lever of the parking brake


For turning on of the parking brake completely lift up the lever located between forward seats. Switching off of the parking brake is made as follows: raise the lever up a little and press the button of a clamp located at an end face of the handle, then lower the lever down. At an otpuskaniye of the parking brake the indicator located on a control panel, should go out, see. Arrangement and functions of governing bodies. If you get under way from a place, without having released completely parking brake, anti-blocking brake system (at its existence on the car) cannot normally function.

Movement with the cocked parking brake will lead to failure of brake mechanisms and bearings of naves of back wheels.

Lighter


The lighter works at two provisions of a key in the ignition lock: ACCESSORY (I) and ON (II). For turning on of the lighter press the handle and drown it before clamp click. After heat of a spiral of the lighter the handle will automatically return to a starting position. Do not hold the lighter handle during spiral heating. It can lead to an overheat and a lighter exit out of operation.


Open a forward ashtray, having pressed its cover, as is shown in an illustration an arrow. After use close an ashtray, having pushed it in the control panel before clamp click. To clear an ashtray of stubs, undertake forward edges of the internal pallet, lift it up and take out outside.


The back ashtray is located in an end face of the central console between backs of forward seats. Open an ashtray, having pressed the upper edge of a cover, as is shown in an illustration. To clear an ashtray of stubs, open it, then lift up and take out from a console nest.

For the cars equipped with ware office in the central console.

Devices of illumination of salon

Plafond of the general illumination of salon


The switch of a plafond of the general illumination of salon has three situation. In the situation OFF It (is switched off) a plafond does not burn. On the average position of the switch the plafond automatically lights up and dies away when opening and closing any door of the car. In the situation ON It (is included) a plafond burns constantly.

The cars equipped with the hatch of a roof

Plafonds of local lighting (separate models)


Switches of plafonds of local lighting have two situation. In the situation OFF It (is switched off) a plafond does not burn. In the situation ON It (is included) a plafond it is included constantly.

CARS WITH THE 3-DOOR BODY THE HATCHBACK

The switch of a plafond of illumination of a luggage compartment can be in one of two provisions: in the top It (is included) or bottom It (is switched off).


If the button of the switch is moved in the top situation, the plafond automatically joins when opening a back door. If the button of the switch is in the bottom situation, the plafond of illumination of a luggage compartment does not work (remains constantly switched off).