Honda Civic/Acura Integra

since 1994 of release

Repair and car operation

Heater and air conditioner

If your car upon purchase was not equipped with air central air. You can establish at any time this system on the car. For this purpose it is necessary to address on HUNDRED Honda for car equipment by central air made at Honda plants and meeting all requirements of our company.

Control panel heating, ventilation and air conditioning

Handle of a regulator of the fan
Handle moving to the right leads to increase in frequency of rotation of the fan and supply of air in car salon.

Handle of a regulator of air temperature

Handle moving to the right leads to increase in the air temperature, the car arriving in salon.

Button of turning on of the conditioner of air (separate models)

The А/С button is intended for inclusion and switching off of the conditioner of air. At the switched-on conditioner the indicator which has been built in the button lights up.

Button of inclusion of a mode of a retsirkulyatsiya of air
The button is intended for inclusion and switching off of a mode of a retsirkulyatsiya of air.

At the included mode of a retsirkulyatsiya (to what the burning indicator which has been built in the button) salon of the car testifies it is isolated from the atmosphere and receipt in salon of fresh air stops. The fan provides air circulation on the closed contour. If repeatedly to press the button and to switch off a retsirkulyatsiya mode (the indicator thus built-in the button will go out), in salon fresh external air from the atmosphere will start to arrive.

Buttons of inclusion of modes of distribution of air

Buttons are intended for a choice of a mode of distribution of air.

External air arrives in salon via the central and lateral ventilating deflectors located in the control panel.

External air arrives in salon at the same time via the central and lateral ventilating deflectors in control panels and the bottom ventilating nozzles which provide supply of air in a zone of an arrangement of feet of the driver and passengers.

External air arrives in salon only through the bottom ventilating nozzles which provide supply of air in a zone of an arrangement of feet of the driver and passengers.

External air arrives in salon at the same time through nozzles обдува wind and the lateral glasses, the control panels located on the top shelf, and through the bottom ventilating nozzles.

External air arrives on having blown wind and lateral glasses through the nozzles located on the top shelf of the control panel.

CARS WITH THE 5-DOOR BODY THE HATCHBACK

Management of deflectors
You can adjust the direction of streams of the air arriving in salon from deflectors, by means of regulators. Direct air in the desirable direction, moving rychazhka of deflectors to the left-to the right and up-down.

Supply of air via the lateral ventilating deflectors located at the left and on the right on the control panel, can be completely stopped. To close or open the lateral ventilating deflector, turn a regulator which is located sideways from the deflector.
The deflector located on the top shelf of the control panel, can be open or closed with the help a rychazhka which is between the central ventilating deflectors.
If one of modes of distribution of air is included or, in the top situation a rychazhka air will arrive in car salon at the same time through central and top ventilating deflectors. To stop intake of air via the top deflector, completely lower a rychazhok down.

Recommendations about operation of a heater and air conditioner

For functioning of systems of heating of salon and air conditioning it is required, that the engine of the car worked. The heater uses hot cooling liquid of the engine for heating of air arriving in salon. If the engine is not heated-up to normal working temperature, some minutes before in salon warm air will start to arrive is required.

In absolute majority of cases the best results of work of the systems providing a comfortable microclimate, are reached in a receipt mode in salon of external air. Long inclusion of a mode of a retsirkulyatsiya of air, especially at the idle conditioner, leads to a zapotevaniye of glasses. Therefore it is recommended to include a mode of a retsirkulyatsiya of air only in case of need and for short time, for example, at movement on the district with the filled with smoke or polluted atmosphere. As soon as need of isolation of salon of the car from the atmosphere disappeared, switch off a mode of a retsirkulyatsiya of air.

External atmospheric air arrives in heating and conditioning systems through the reception lattice located before a windscreen. Periodically clear openings of a reception lattice of leaves and the other garbage complicating passing of air.

Ventilation of salon of the car

The system of a supply and exhaust ventilation provides a constant exchange of air in car salon. The fresh external air arriving through a forward reception lattice, circulates on salon and then is removed through the exhaust outlets located about back glass.

PERFORMANCE ORDER

1. Shift the handle of a regulator of temperature in extreme left situation. Check, that the conditioner of air was switched off. 2. Include a mode of distribution of air, having pressed the corresponding button. The mode of a retsirkulyatsiya of air should be switched off. 3. By means of the handle of a regulator of the fan establish desirable level of supply of air in salon.

Air cooling in car salon (separate models)

If the car staid a long time on the sun, and air in salon strongly heated up, you can lower quickly air temperature in salon as follows.

Work of central air of air leads to additional load of the car engine. Therefore watch closely an arrow of the index of temperature of cooling liquid, moving with small speed in street jams or overcoming long liftings of a considerable steepness. If the arrow was displaced to a red zone of a scale, temporarily switch off the air conditioner until the temperature of the engine will not settle into shape.

Heating of salon of the car

To lift air temperature in car salon, execute the following.

Salon heating with simultaneous drainage of air (separate models)

At central air work humidity of air decreases. Therefore simultaneous inclusion of a heater and the conditioner allows to make air in car salon warm and dry.

Joint inclusion of systems of heating and air conditioning can be applied in any traffic conditions when the temperature of air is higher 0°С.

Moisture and hoarfrost removal from glasses

To clear internal surfaces of glasses of the condensed moisture it is possible as follows.

To remove from an external surface of glasses hoarfrost or the ice formed after parking of the car on the street in frosty weather, execute the following.

In a mode обдува glasses all air arrives in salon through the slot-hole nozzles located on the top shelf of the control panel at the basis of a windscreen, and via lateral ventilating deflectors which are along the edges of the control panel. The air temperature, blowing glass, and speed of purification of glasses increase in process of engine warming up. For faster removal from a windscreen of condensate, hoarfrost or ice you can close lateral ventilating deflectors, having turned the corresponding regulators down. In this case all air will go only on having blown in a windscreen.

For reasons of safety do not begin movement until all windows will not be cleared of condensate, hoarfrost or ice and to you the good review from the car will not be provided.

Switching off of systems of heating and ventilation

Temporarily to disconnect heating and ventilation systems, move to extreme left position of the handle of regulators of the fan and air temperature.
Shutdown of system of heating is necessary in the first some minutes after engine start in cold weather. It provides faster warming up of the engine to temperature, sufficient for effective work of a heater. In all other cases keep the fan constantly included in congestion avoidance in salon of a dead air.