Honda Civic/Acura Integra

since 1994 of release

Repair and car operation



Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
- Maintenance instruction
   Arrangement and functions of governing bodies
   Keys and locks
   Adjustment of seats
   The equipment and governing bodies in salon
   Heater and air conditioner
   Control system of a salon microclimate
   Audiosystem
   Safety systems
   Running in of the new car
   Cowl unlocking
   The valve of shutdown of supply of fuel in case of failure (on some models)
   Engine start
   Five-step manual box of gear shifting
   Automatic transmission
   Besstupenchaty variator (separate models)
   Devices of external lighting and trailer alarm system
   Check of level of liquid in automatic transmission
   Driving belts
   Emergency closing of the panel of the hatch of a roof
   Safety locks
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Safety locks

All chains of the electric equipment of your car are protected from damages at short circuits or an overload by fuses. Electric safety locks are concentrated in two or three blocks.

The Podkapotny block of safety locks is located in an impellent compartment near the storage battery. To open a cover of the block of safety locks, press a clamp pad, as is shown in an illustration.


On the cars equipped with anti-blocking brake system, the third block of safety locks which protect electric chains of ABS in addition is established. The block of safety locks of ABS is on the right side of an impellent compartment (or on the left side if to look in front of the car).

One more block of electric safety locks - — internal – is located at the left under the control panel. For access to safety locks it is necessary to uncover previously, closing panel with safety locks (instructions on dismantle of a cover are provided below).

In cars with the right wheel (except the updatings intended for delivery to Australia) the internal block of electric safety locks it is located behind office for personal belongings of the driver in the heart of the control panel. For access to safety locks it is necessary to take out a box closing them from the control panel.

Cars with the left wheel


To dismantle a cover of the block of safety locks, open it before horizontal situation and take out from sharnirny support, having pulled on itself.

The updatings of the car intended for delivery to Australia


Completely open a cover of the block of safety locks. Then press bottom edge of a cover up and uncover, having pulled it on itself. To put a cover into place, establish the bottom arms of a cover on the sharnirny support located in a nest, and close a cover.

Cars with the right wheel (except the updatings intended for delivery to Australia)


To dismantle a box for personal belongings of the driver, at first completely open it, then press bottom edge of a box and take out it from a panel nest.

To establish a box for personal belongings of the driver into place, execute the following.

 PERFORMANCE ORDER

1. Get the top emphasis on a back wall of a box for pads of limiters which are located in a nest. Then press a box from below up, as is shown in an illustration.

2. Press bottom edge of a cover of a box that both bottom sharnirny support of a box entered into the corresponding grooves of a box. Check, that the box freely turned in sharnirny support.