Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
Specifications
Care of components of a body and car bottom
Care of vinyl elements of furnish
Care of an upholstery and salon carpets
Repair of insignificant damages of body panels
Repair of seriously damaged body panels
Service of loops and car locks
Replacement wind and other fixed glasses
Removal, installation and adjustment of provision of a cowl
Removal and installation of a latch of the lock of a cowl and cable of its drive
Removal and installation of assemblies of forward and back bumpers
Removal and installation of forward wings
Removal and installation of a latch, cylinder of the lock and emphasis of a door of a back
Removal, installation and adjustment of a door of a back
Removal and installation of a latch, cylinder of the lock and emphasis of a cover of a luggage compartment
Removal, installation and adjustment of a cover of a luggage compartment
Driving cables of an otpuskaniye of locks of covers of a luggage compartment and hatch of a jellied mouth of a fuel tank
Removal and installation of an internal upholstery of doors
Removal, installation and adjustment of provision of doors
Removal and installation of latches and cylinders of locks and external and internal handles of doors
Removal and installation of door glasses
Removal and installation of a regulator of a window regulator
Removal and installation of rear-view mirrors
Removal and installation of the central console
Removal and dashboard installation
Removal and installation of a casing of a steering column
Removal and installation of an instrument guard
Removal and installation of a forward fairing
Removal and installation of seats
+ Control body sizes
+ Onboard electric equipment
|
Removal and installation of latches and cylinders of locks and external and internal handles of doors
Assembly of a latch of the lock
|
|
1. Lift a windowpane and remove the panel of an internal upholstery of a door (see. Removal and installation of an internal upholstery of doors).
|
|
2. Through a big opening in a doorframe disconnect a rod connecting the external handle to a latch. The same do with a rod of the internal handle, and also with rods of external and internal locks and the electromagnetic actuation mechanism (at the corresponding complete set) (see an accompanying illustration). |
3. All rods fasten by means of plastic clamps. Release entering into gearing with a rod a part of a clamp, then pull a rod, liberating it from a landing opening.
|
|
4. Turn out screws of fastening of a latch to a door (see an accompanying illustration). Take latch assembly through the opening provided in a doorframe. |
5. Installation is made upside-down. |
|
External handle and cylinder of the door lock
|
|
1. Close a window and remove the panel of an internal upholstery of a door and the water filter (see. Removal and installation of an internal upholstery of doors).
|
|
2. Through an opening in a doorframe release plastic clamps of fastening to a latch of executive rods external the handle and the door lock (see an accompanying illustration). |
3. Turn out bolts of fastening of the external handle (see an illustration above).
4. Remove the handle and assembly of the cylinder of the lock from the car.
5. Installation is made upside-down. |
|
Internal handle
|
|
1. Remove the panel of an internal upholstery and separate the water filter (see. Removal and installation of an internal upholstery of doors).
|
|
2. Release directing an executive rod, then turn out screws of fastening of the handle (see an accompanying illustration).
|
3. Liberate the handle from a door and disconnect from its back party an executive rod. Remove the handle.
4. Installation is made upside-down. |
|
|
|
