Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
- Power supply system and release
   Specifications
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of fuel pump/pressure of fuel
   Check of a condition and replacement of fuel lines and their shtutserny connections
   Removal and installation of the fuel pump
   Check of a condition and replacement of the sensor of fuel consumption
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of fuel of injectors of fuel
   Release system - the general information
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Removal and installation of a fuel tank

See preventions at the beginning of Sbrasyvaniye of pressure in a power supply system.


Procedure performance considerably becomes simpler, if a fuel tank beforehand to devastate.


 PERFORMANCE ORDER

1. For the purpose of dumping of superfluous pressure uncover a jellied mouth of a fuel tank.
2. Dump residual pressure in a power supply system (see Sbrasyvaniye pressure in a power supply system).
3. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!


4. Turn out a drain stopper and lower the fuel which has remained in a tank in the prepared capacity of suitable volume (see an accompanying illustration). If the drain stopper is not provided, pump out fuel by means of a special set which can be got practically in any shop of automobile accessories.


At all do not suck away gasoline a mouth!


5. Remove a back seat (see. Head the Body) also disconnect electroconducting from the sensor of fuel consumption and the fuel pump (see. Check of a condition and replacement of fuel lines and their shtutserny connections and Removal and installation of the fuel pump). Also disconnect from the pump fuel hoses (see. Check of a condition and replacement of fuel lines and their shtutserny connections).
6. To Poddomkratta a car back also establish it on props.

7a. Remove protective panels of a fuel tank and fuel lines. On the Civic models one big panel is used.

7b. On the Integra models – two small (see accompanying illustrations).

8. Mark and disconnect fuel hoses and arms of their fastening on a tank (see an accompanying illustration).

9. Prop up a fuel tank a floor jack. For distribution of loading lay between a head of a jack and the tank bottom a strong wooden bar.

10. Give bolts of fastening of both assembly brackets of a fuel tank (see an accompanying illustration).

11. Lower brackets and take a tank from under the car.
12. Installation is made upside-down.