Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ cooling and heating Systems
- Power supply system and release
Specifications
Sbrasyvaniye of pressure in a power supply system
Check of serviceability of functioning of fuel pump/pressure of fuel
Check of a condition and replacement of fuel lines and their shtutserny connections
Removal and installation of the fuel pump
Check of a condition and replacement of the sensor of fuel consumption
Removal and installation of a fuel tank
Cleaning and repair of a fuel tank - general information
Removal and installation of assembly of an air purifier
Removal, installation and adjustment of a cable of an accelerator
System of electronic injection of fuel (EFI) - the general information
Check of serviceability of functioning of system of injection
Removal and installation of the case of a throttle
Removal and installation of a regulator of pressure of fuel
Removal and installation of the fuel highway and injectors of fuel of injectors of fuel
Release system - the general information
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal, installation and adjustment of a cable of an accelerator Replacement
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action! |
|
|
2. Weaken a lock-nut and liberate an accelerator cable from an arm (see an accompanying illustration). |
|
|
3. Turn the cranked lever of a butterfly valve and take from the groove in the lever a cable tip (see an accompanying illustration). |
|
|
4. Under the dashboard in a driver's foot well disconnect an accelerator cable from a gas pedal (see an accompanying illustration). |
5. Liberate from a partition of an impellent compartment the rubber plug through passage, then involve cable assembly in car salon.
6. Installation is made upside-down. Track, that the sealing plug of a cable through passage correctly was planted in a partition of an impellent compartment. Choose a cable weak point, then pass to its adjustment. |
|
Adjustment
|
|
1. Start the engine and warm up it to normal working temperature, then leave working at single turns.
|
|
2. Estimate deflection size (lateral люфта) a cable on a site between the cranked lever of a butterfly valve and an arm (see an accompanying illustration). Люфт should lie within a range 9.5÷12.7 mm, otherwise weaken a lock-nut and make the corresponding adjustment. Again strongly tighten a lock-nut and muffle the engine. |
3. By means of the assistant make sure of completeness of opening and butterfly valve closing. Check freedom of a course of a cable.
4. On equipped AT models make adjustment of draft of management by a butterfly valve in the kick-down mode (TV cable) (see. Part 4-step and besstupenchaty automatic transmissions (ат and cvt)). |
|
|
|
