1. Weaken nuts of fastening of the corresponding back wheel. To Poddomkratta a car back also establish it on props. Remove a wheel.
2. Remove a brake drum/support with a disk (see. Head Brake system).
|
|
3. By means of a hammer and a chisel remove a dustproof cover (see an accompanying illustration). |
|
|
4a. To Raschekanta a stupichny (shpindelny) nut (see an accompanying illustration), then give it, remove a persistent washer and a wheel nave. |
|
|
4b. The nave should act in film rather freely, in case of difficulties use a stripper on the basis of a hammer with sliding brisk (see an accompanying illustration). |
|
|
5. Establish new stupichny assembly and a persistent washer. Tighten a new stupichny nut with demanded effort. Do not forget зачеканить a nut (see an accompanying illustration). |
6. Establish into place a dustproof cover, for reliability of landing slightly обстучав it on perimeter.
7. Further installation is made as it should be, the return to an order of dismantle of components. |
|
