1. After performance of any procedures connected with a detachment of lines of the hydraulic booster, it is necessary to remove air from a hydraulic path of PAS. Otherwise efficiency of functioning of the steering amplifier in considerably measure will decrease.
2. Develop forward wheels of the car in rectilinear situation and check level in the PAS system tank. (See. Head Routine maintenance). In case of need make the corresponding adjustment (level of liquid should reach the bottom point in a tank wall).
3. Start the engine and leave its working at turns of fast idling. Once again check liquid level in the PAS tank. In case of need again make adjustment.
4. Rotation of a steering wheel here and there (without blows in the course ends) give from system air (watch that liquid level in the tank during pumping did not fall below an admissible limit).
5. Having finished pumping, return wheels to rectilinear situation and let's to the engine work within several more minutes, then muffle it.
6. Make trial runs of the car, checking serviceability and noiselessness of functioning of steering system.
7. Once again check level of hydraulic liquid at the heated-up engine to normal working temperature (this time it should reach a mark of NOTES in a tank wall). In case of need make necessary adjustment (see. Head Routine maintenance). |
|
