1. Weaken nuts of fastening of the corresponding forward wheel. To Poddomkratta the car also establish it on props. Remove a wheel. Prop up the bottom lever of a suspension bracket a jack.
|
|
2. Take шплинт and weaken a koronchaty nut of a spherical finger of a support of the top lever (see an accompanying illustration). Do not remove while a nut finally in order to avoid spontaneous separation of the lever from a rotary fist. |
|
|
3. By means of a stripper liberate a sharovy finger of a support of the top lever from a rotary fist (see an accompanying illustration). Remove a koronchaty nut (try not to allow fist losses, in case of need tie up amortizatorny assembly by a wire). |
|
|
4a. On the Civic models, working in an impellent compartment, give nuts, take axial bolts. |
|
|
4b. Cнимите assembly of the top lever from the car (see accompanying illustrations). |
|
|
5. On the Integra models give nuts of fastening of the top lever to the shock basis (see an accompanying illustration) and remove the lever, having led round it round a screw spring. |
6. Installation is made upside-down. Track observance of demanded efforts of a tightening of fixture.
|
|
On the Civic models raise a forward suspension bracket a jack, simulating its full speed during movement and after it tighten axial bolts of the lever.
|
|
|
