1. Prepare fresh transmission liquid of the corresponding grade (see. Specifications at the beginning of Head).
2. Number of other necessary tools and materials treat: props for car fixing in the lifted situation, a ratchet drive on 3/8 inches (with the extension piece) to a face key, drain capacity in volume not less than 5 l and a stock of rags and/or old newspapers.
3. Liquid should merge previously being heated-up to normal working temperature during a short trip. Hot ATF possesses higher fluidity and better washes away шлам and other deposits.
|
|
The working temperature of ATF can reach 180°С – be careful, work in rubber gloves. |
4. Having made a short trip and ATF warming up to normal working temperature, park the car on an equal horizontal platform with a firm covering, поддомкратьте it and establish on props, having provided a free access to a drain stopper of a case of transmission.
5. Get under a transmission case drain capacity and all necessary stock. Try not at to concern to located under with the bottom of the car of the warmed-up components of the power unit and system of production of the fulfilled gases.
|
|
6. Having placed properly reception container, turn out located on the right side of a case of transmission a drain stopper (see an accompanying illustration). Do not forget that during the first moment of ATF will start to follow with a relative pressure which, in process of decrease of level of liquid, will gradually decrease – be ready to correct the provision of drain capacity in time. When the liquid effluence absolutely will stop, wipe a drain stopper, screw it on the regular place and strongly tighten. |
7. Lower the car on the earth.
8. Without starting the engine, take from a transmission case measuring щуп and through the released opening fill in necessary amount of fresh liquid of a demanded grade (see. Specifications). For the purpose of minimization of losses of ATF use a funnel. Fill in liquid in the small portions, periodically checking its level on щупу (see. Check of level of ATF AT/CVT (each 4 800 km of run or time in three months)).
9. Start the engine and slowly carry out the selector lever through all provisions, having finished in the situation "R". Having finished, strongly cock the parking brake.
10. Muffle the engine and check ATF level. In case of need make the corresponding adjustment (level of liquid should be approximately in the middle of the site of an edge covered with notches щупа. |
|
