|
|
1. Take measuring щуп, located in the lower part of a case of transmission near the right partition of an impellent compartment (see an accompanying illustration). Fingers remove from an edge щупа traces of ATF and estimate its condition. |
2. Carefully wipe an edge pure rags and enter щуп back into directing tube, having densely planted a mouth cover.
|
|
3. Again take щуп from a mouth and by size of the moistened site of an edge determine ATF level in a transmission case (see an accompanying illustration). In case of need make the corresponding adjustment, having added in transmission through a funnel liquid of a demanded grade (fill in liquid directly in a mouth of a directing tube measuring щупа). |
4. Lifting of level of ATF from the bottom border of a working range щупа to top needs about 1 l of liquid – the flood is made in the small portions in stages, each time checking level.
5. At the same time with level it is necessary to check as well ATF condition. If the liquid moistening the end of an edge щупа has a dark red-brown shade, or smells as ashes, ATF should replace (see. Check and adjustment of turns of idling (each 48 000 km of run or time in 24 months)). In case of absence of confidence of correctness of an assessment of a condition of transmission liquid compare it on color and a smell to the fresh. |
|
