Removal and installation of the aerial of a radio receiver
Civic models
|
1. Disconnect an antenna cable from a radio receiver (see. Removal and installation of a radio receiver and loudspeakers). 2. Tie up by the end of an antenna cable a piece of a string.
|
3. Turn out fixing screws and remove the aerial from a body rack (see an accompanying illustration). |
4. Tie up a string, having attached it to a cable of the new aerial. Omit antenna assembly on the regular place, at the same time involving a cable for a string in a rack. 5. Untie a string and connect an antenna cable to radio receiver assembly. Screw screws of fastening of antenna assembly and strongly them tighten. |
|
Integra models
Mast of the aerial equipped with the electric drive
|
|
1. Stick with an adhesive tape surrounding antenna mast a part of a wing of the car for protection of a paint and varnish covering. Give a fixing nut and remove a remote washer (see an accompanying illustration). |
|
2. Ask the assistant to include a radio receiver and to lift the aerial in the top situation. Directing an aerial mast in process of promotion, remove it from the car (see an accompanying illustration). |
|
3. At installation develop the aerial teeths back and enter teeths into gearing with a driving cable. Include a radio receiver and allow the electromotor to involve an aerial mast in a wing (see an accompanying illustration). |
4. Establish into place a remote washer and screw a fixing nut.
|
If the remote washer is equipped with a flat sealant, the last should enter in the plug, settling down under a washer. The sealing ring is put over a remote washer. |
|
|
Electromotor of a drive of an antenna mast
|
1. On models with a body of the Sedan type remove the panel of a lateral internal upholstery in a luggage compartment. On the Hatchback models remove the Back lateral panel of an internal upholstery of salon.
|
2. Give a nut of fastening of the aerial, remove a washer (see an illustration). Give a nut of fastening of the driving electromotor (see an accompanying illustration). Disunite the electric socket and an antenna cable. Remove electromotor assembly. |
3. Installation is made upside-down. |
|
|