Chain breakers
Breakers of a chain are used for protection of such components of system of onboard electric equipment, as head headlights, resistors of modules of safety cushions, electromotors of a drive of window regulators/activators of door locks, etc.
On some models after operation breakers revert to the original state automatically. If causing breaker shutdown the overload had not incidental character, it is necessary to check a condition of the corresponding contour immediately. After malfunction elimination the chain breaker enters again into a normal mode of functioning. Sometimes return of the breaker to a working condition should be made manually after elimination of the reason of an overload.
For breaker introduction in a working condition disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action! |
Take the breaker, pass a thin core in specially provided opening in the case and push it in an opening before click. Then it is meaningful to make sure by means of an ohmmeter available conductivity between plugs of the breaker and after it to establish it into place. |
