Honda Civic/Acura Integra

since 1994 of release

Repair and car operation

Check of serviceability of functioning and replacement of podrulevy switches

Considered in the real Management of the car are equipped with safety cushions (SRS). At performance of any works near sensors of blows, a steering column or the dashboard disconnect SRS (see. Safety cushions - the general information). Do not make check of the SRS models by means of any type of the diagnostic equipment.

The combined podrulevy switches of management of lighting devices and cleaners/washers of glasses

Check

PERFORMANCE ORDER

1. The combined switch of external lighting is located on the left side of a column and provides management of functioning of indexes of turns, head headlights, a light signal and parking fires. From the opposite side of a column there is a switch of management of cleaners/washers of glasses.
2. Remove the switch (and) (see paragraph 1, Replacement).

3a. By means of an ohmmeter or the lamp sampler equipped with the individual power supply check correctness of existence of conductivity between switch plugs in its various provisions (see accompanying illustrations and tables is lower): an ID card of plugs of the combined podrulevy switch of management of lighting devices

3b. An ID card of plugs of the combined podrulevy switch of management of windscreen cleaners/washers. In case of identification of violations replace the switch.

Card of conditions of the podrulevy switch of management of lighting devices

POSITION OF THE SWITCH	CONDUCTIVITY EXISTENCE BETWEEN PLUGS
Parking fires	1 and 2
Head headlights (passing beam)
Civic (USA)	1 and 2; 3 and 6
Civic (Canada)	1 and 2; 3, 4 and 6
Integra	1 and 2; 4 and 6
Head headlights (driving beam)
Civic (USA)	1 and 2; 5 and 6
Civic (Canada)	1 and 2; 4, 5 and 6
Integra	1 and 2; 4, 5 and 6
Blinking head headlights	5 and 6
Indexes of the right turn	8 and 10
Indexes of the left turn	8 and 9

Card of conditions of the podrulevy switch of management of cleaners/washers of wind and back glasses

POSITION OF THE SWITCH	CONDUCTIVITY EXISTENCE BETWEEN PLUGS
SWITCH OF MANAGEMENT OF WINDSCREEN CLEANERS/WASHERS
Vykl	1 and 7
Interval mode	1 and 7; 3 and 4
Slow mode	1 and 5
Fast mode	2 and 5
Glass washing	4 and 8
Fog	2 and 5
SWITCH OF MANAGEMENT OF CLEANERS/WASHERS OF BACK GLASS
Vykl	1 and 2
R	1 and 3
Glass washing	4 and 6

Replacement

PERFORMANCE ORDER

1a. Remove sections of a casing of a steering column. By means of a small screw-driver accurately disunite the electric socket of the switch. Turn out two fixing screws.

1b. Remove switch assembly from a steering column (see accompanying illustrations).

2. Installation is made upside-down.

Switch of management functioning of a control system by the speed (tempostaty)

Check

PERFORMANCE ORDER

1. Remove the switch from a steering column (see paragraph 3 below).

2. By means of an ohmmeter or the lamp sampler equipped with the individual power supply check conductivity existence between switch plugs in its both provisions (see an accompanying illustration). In case of need replace assembly.

Replacement

PERFORMANCE ORDER

1. Disconnect a negative wire from the battery and wait at least three minutes before starting procedure performance.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove from the switch a cover.

3. Turn out fixing screws (see an accompanying illustration), disunite electric sockets and remove the switch from a steering wheel.

3. Installation is made upside-down.