Honda Civic/Acura Integra

since 1994 of release

Repair and car operation

Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
- Engine
   - Engine repair without extraction from the car - the Civic models
      General information
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of a cover of a head of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      VTEC systems - the general information and check of a condition of components
      Removal, check of a condition and installation of assembly of yokes
      Replacement of klapanny springs with plates and maslootrazhatelny caps
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      Removal, check of a condition and camshaft installation
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and flywheel installation / driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + engine Repair without extraction from the car - the Integra models
   + General and major maintenance of the engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Replacement of a back epiploon of a cranked shaft

PERFORMANCE ORDER

1. Remove a transmission (see. Head gear shifting Box).
2. Remove a flywheel / a driving disk (see. Removal and flywheel installation / driving disk).
3. Before removal of an old epiploon surely measure gap size between its face surface and external edge of the holder (use a small ruler or Columbus). Write down results of measurement – the new epiploon should be planted strictly on the same depth (see. Part General and major maintenance of the engine of the present Chapter).

4. Replacement of an epiploon can be made without preliminary dismantle of the pallet of a case and the holder of an epiploon. Having accurately hooked a screw-driver, take an old epiploon from a landing nest in the holder (see an accompanying illustration).

Not to damage a pin of a shaft or a wall of a nest wrap up a screw-driver sting rags.

5. Slightly grease edges of a pin and a sponge of a new epiploon with universal greasing, then, helping itself a blunt tool, put on an epiploon a shaft (see an accompanying illustration). By means of an opravka and a hammer plant an epiploon in a nest (as an opravka the face head of the corresponding size, or a piece of a pipe of suitable diameter [slightly less external diameter of an epiploon] can be used).

The description of procedure of replacement of an epiploon with demontazhy the holder is provided in the Part the General and major maintenance of the engine of the present Chapter.

5. Further installation is made as it should be, back to a dismantle order.
6. Start the engine and check its existence of leakages of oil.