Honda Civic/Acura Integra

since 1994 of release

Repair and car operation


Honda Tsivik
+ Honda Civic and Acura Integra brand Cars
+ Maintenance instruction
+ Routine maintenance
- Engine
   - Engine repair without extraction from the car - the Civic models
      General information
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of a cover of a head of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      VTEC systems - the general information and check of a condition of components
      Removal, check of a condition and installation of assembly of yokes
      Replacement of klapanny springs with plates and maslootrazhatelny caps
      Removal, check of a condition and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Replacement of a forward epiploon of a cranked shaft
      Removal, check of a condition and camshaft installation
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and flywheel installation / driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + engine Repair without extraction from the car - the Integra models
   + General and major maintenance of the engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ gear shifting Box
+ clutch and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




94e743ed

Check of a condition and replacement of support of a suspension bracket of the power unit

Support of a suspension bracket of the power unit extremely seldom need the attention, however the damaged pillows should be replaced without any delay in order to avoid increase of loadings and premature wear of components of the transmission line.

Check

 PERFORMANCE ORDER

1. For check it is necessary to raise slightly the engine, having unloaded support.
2. To Poddomkratta the car also establish it on props. Get a jack under the pallet of a case of the engine (for the purpose of distribution of loading lay between a head of a jack and the pallet wooden whetstone). Cock a jack, having slightly raised the engine and having unloaded support.

At all do not perform any works under the car, withheld in the lifted situation by means of only one jack!


3. Check pillows of support on existence of cracks, signs of hardening of rubber and separation from the metal basis. Sometimes pillows start to break directly in the middle.
4. Estimate size люфта between components of support and power a car unit/frame (as the lever use mount or a big screw-driver). In case of identification люфта lower the unit and tighten fixture of support.
5. Pillows in order to avoid destruction of rubber should be processed by special protective structure.

Replacement

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!


To Poddomkratta the car also establish it on props. Prop up the engine.
2. Release fixture, raise the engine a jack and remove a support, having separated it from a frame and engine arm.

3a. Replace a pillow. Track correctness of landing of assembly in an arm (see accompanying illustrations): left support of the engine.

3b. Right lateral support of a transmission.

3с. Back support of the engine.

3d. The right forward support with an arm on a transmission case. Screw fixture and strongly tighten it.